2. digital
  3. 163272-135704

High Frequency Oscillation hurt resistors in Magico A5 crossovers

Hi,I am looking for help understanding how HFO could blow crossover resistors in Magico A5 speakers. Equipment playing at the time of the incident is as follows...
Magico A5 speakersHegel H30 mono blocksHegel P30 preamp (lt and rt inputs on the Aux inputs from the laptop and Dragonfly Cobalt)
Dell laptopAudioquest Dragonfly CobaltAmazon Hi-res streaming
I was listening to Amazon music at a very moderate level when the application said there was an update available.I instinctively clicked accept while music was paying. It was only off for a few seconds to update and when complete and I restarted music the A5 tweeters were not on. These happened simultaneously and there was no audible noise what so ever indicating a potential issue. After multiple source tests and tweeter test, I was certain the tweeters were fine and it was an electronic issue. The cross overs were removed and sent to Magico and that was when I was told that HFO blew the resistors.
Can anyone explain how/why this happened so I can ideally avoid it happening again?
Thank you!
128x128howaanders8
erik_squires
15,657 posts
 
I'm not sure what the plastic tweeter reference is about, but the best AMT's have phenomenal resistance to overloading.  They will survive power bursts that would make almost any dynamic tweeter turn into a projectile.

Best,

Erik
howaanders8's avatar
howaanders8 OP
17 posts
 
Enough ladies... I was simply looking for an explanation to my problem. Thanks for everyone who took my inquire seriously.
cal3713's avatar
cal3713
1,421 posts
 
Wouldn't be a 2020/21 audiogon thread if at least two participants didn't actively search for ways to fight with one another.  I wish I could say that I found such behavior entertaining, but honestly it just sucks the joy out of this place.

Anyway, at least you got some useful information out of the group. And thank God those resistors were there and were not over-rated. Please do provide further updates if you get any additional information.
howaanders8's avatar
howaanders8 OP
17 posts
 
Will do, thank you.
kellyp's avatar
kellyp
104 posts
 
I think the LF > HFO etc has been covered adequately.  A schematic of your crossover would help. Anyway, with updates, components are reset, turned off, turned on.  It is reasonable that the +5V PS voltage to your USB DAC was also reset.  The switch mode PS used are 200-300 kHz.  The voltage has to settle.  And the ripple, particularly with Dell products is already quite bad.  The dragonfly has some PS filtration, but it is not great.  Being as this happened during a reset, and that is the way resets work, it is my best guess.  I would not expect your speaker engineers to shed and light on something like this. 

This may happen again for no fault of your own.  How can you avoid this?  Get an outboard PS/USB and forget the laptops poor voltage source.  Not only will you add protection, you should experience better fidelity.

More to discover