Many amps actually go right down to DC. The upper limit is peculiar to that am and it's design but I no of no amp that does not pass by 20 kHz gracefully. What is it exactly that you are worried about and why?
- ...
- 9 posts total
I would get a digital test album like this one
https://www.hdtracks.com/#/album/5ddb5ef3848da9f501f6db95 Then you will need a broad bandwidth multimeter. This will check everything but your turntable. For that get the Hi Fi News Test Record. |
I have a 30 year old ARC CL 60 that appears to be a few decibels down in the higher frequencies in the right channel. But it’s subtle; so I’m not 100% sure. I have eliminated all of he other variables including, it not limited to, cables, tubes, flip flopping speakers - and tubes and sources. So I figured I do an empirical test before sending it in. |
An inexpensive signal generator is what you need. Connect the signal generator to the amp, with level all the way down. Get a DB level meter and from the lowest frequency to the highest, go for it. Set it at 1KHZ first and a decent output level from your amp as measured on the DB meter. Then go to 10 HZ, 20 HZ, etc. up to 20 KHZ and see if the output stays flat. It should rise up to the -3DB point and then stay relatively flat until around 20 KHZ and start to roll off. enjoy |
Also, you want to measure this directly from the amp, not through the pre-amp to the amp. in addition, if you really want this done right. use a Osciloscope instead of a DB meter. But, we are talking inexpensive here. So a Radio Shack DB meter (or app on cell phone), and an inexpensive signal generator. Plug the output of the signal generator into one channel of the amp, Set the DB meter 1 meter away from the speaker and start the test. enjoy |
- 9 posts total