TA-102 fo.Q Product from Japan "TRY These"

Damn I felt sorry jkbtn I was a fool, something's wrong with that fella. At least I discovered a product that's cheap and should work. I'm a big believer in vibration control to lowers noise floor. This should be fun to see what improvements I can get out of $70. Don't think I'm going to buy 50 packs like batmobile, at least I hope not. Hope you have you run out of places to put it, your in it for over $1500 in tape. When does this end?

I used 12 full packs just to line the entire insides / underneath of my Kuzma Stabi M. Results are mind-boggling.

http://www.g45central.com/posts/Kuzma100.jpg

Well someone obviously thinks he can be sneaky and repost the same drivel ( with a couple of minor snips)that a mod just deleted and it will now be fine.

Says all I need to know .......

And no it was not I that reported your prior post, I actually do have a life amazing as that may seem... Lol.

batmobile you stated go liberal on speaker baskets. I used mortite caulking puddly rope long ago on speaker baskets and there was a definite improvement. On a 6 1/2 inch driver how big of a piece do you consider liberal on each rib of basket. Now I'm on my way to 50 packs.

Hi Paul -
I would consider covering any or all parts of the metal ribbing of speaker baskets, to suit your taste. I would personally cover all of the metal basket. I don’t think you could over-do it with fo.Q, unless you happen to like metallic ringing and distortion as part of the sonic blend (some do!). The basket isn’t really technically part of the transducer therefore it shouldn’t be vibrating at all. Maybe start with one 20mm strip on each rib to see if you like it. If you like it, adding more will give you more of what you like.
Because fo.Q deals with low amplitude vibrations very efficiently, it is not subject to the same sonic pitfall as other damping materials (or at least to a much lesser extent). Namely, absorbing certain frequencies but leaving others behind to dominate and muddy the sound.