2. amps-preamps
  3. 138255-3568

RCA to XLR vs XLR to RCA... Converting Input or Output - Does It Matter??

I just picked up a new DAC that only has RCA outputs whilst my preamp only has XLR inputs.  realizing that a DI box like the Jensen ISO-Max is the proper way to resolve this incompatibility, that's not an immediate solution for me.  in the short term, i was going to use adapters on either the DAC outputs or the preamp inputs.  given the following options, is there any benefit to one vs the other (emi/rfi, noise, etc)...

Option 1:
convert the RCA output on the DAC to XLR via an RCA Male to XLR Male adapter and connect the components using an XLR cable.

Option 2;
convert the XLR input on the preamp to RCA via an RCA Female to XLR Male adapter and connect the components using an RCA cable.

as an alternative to the above, i could also use a converter cable, RCA male to XLR male as a short-term solution.

i know none of the above will turn an unbalanced signal to balanced - these are really only to address jack incompatibilities - and the proper solution is a transformer.  until i'm able to implement that, is there a preferred method from those above?

thanks for any inputs.  
128x128srosenberg
srosenberg's avatar
srosenberg OP
209 posts
 
@sbank as was already mentioned, Jensen can configure their transformers RCA to XLR or XLR to RCA - take note of the order of the X and R in the product ID as this will indicate the ins and outs.  there are three units: PI, PO and PB as detailed here: https://www.cs1.net/learn/jensen_transformers_application_guide.htm

And as Inna mentioned, you can have cable made from a number of places... PAD, BlueJeans, Benchmark (yep, they sell cables, too).

@almarg thanks for the note... good to know there's not an absolute 'right way' to handle the jack adapters.
atmasphere's avatar
atmasphere
11,595 posts
 
@srosenberg
You might ask BAT how well their preamp does with single-ended inputs.
Our balanced preamps don't seem to care much if the input is single-ended, in fact we provide RCA connections for that purpose. The preamp converts any single-ended input to balanced. I suspect the BAT does too, as one of their founders owned one of our preamps before starting up BAT.

The reason for this is the gain section, like our preamps, is likely a differential amplifier with a fairly high CMRR (Common Mode Rejection Ratio) figure. The higher it is, the less the preamp cares about whether the input is balanced or not, and there is a tipping point where that will be preferred over an input transformer.
sbank's avatar
sbank
3,378 posts
 
@atmasphere Ralph, BAT says their preamps do fine using adapters into their xlrs & they sell adapters like I currently use without trouble. I was just wondering if replacing the adapters w/Jensen tranny and adding another cable would be likely to provide enough Sq improvement to justify the cost.
@almarg thanks for clarification on the various models. Got an opinion on if it would be worthwhile? Cheers,
Spencer 
atmasphere's avatar
atmasphere
11,595 posts
 
I was just wondering if replacing the adapters w/Jensen tranny and adding another cable would be likely to provide enough Sq improvement to justify the cost.
I doubt it very much. The less transformers in the signal chain the better IME.
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
@sbank, I have no reason to doubt Ralph’s good comments. And especially given that the Nagra is battery-powered, which eliminates any possibility of ground loop issues with the Nagra/BAT combination, that a Jensen transformer would be able to resolve.

Best regards,
-- Al
More to discover