2. pc-audio
  3. 133929-364

Aurender N100H Mods

The fact that Aurender runs Linux makes changing the system difficult but I have managed the following. 

Convert a 220v unit to 110v for US service and back the other way is relatively easy. A few wiring changes. 

Upgrade boot and SSD music cache from 120GB mSATA to faster and larger 256GB mSATA is possible but not for the novice. 

Upgrading 2TB HD to 4TB now. 2TB units have their 2nd drive pins omitted so to go larger you can’t add a second drive. Need to replace the smaller drive with a larger one.  Needs to be formatted or cloned to conform to Linux. 
fm540i
mattmiller's avatar
mattmiller
1,479 posts
 
That is really kool (I could never do that), but ill bet most people who can afford to buy a Aurender dont feel comfortable taking it apart like you did! #ballz....ROFL


Matt M
fm540i OP
47 posts
 
I’d never try it with an N10 but I was fortunate to buy a 220v N100h cheap. There just fancy computers. I knew it contained a dual voltage transformer so adapting it to US voltage was easy. The Linux operating system makes it more difficult to play with boot discs and hard drives but with a little research I was able to clone the boot drive and copy the HD partition to a larger hard drive. 
sprucewolf
1 posts
 
it'd be great if you could post tutorials somewhere and link them here, or write them here as posts. 
Post removed 
fm540i OP
47 posts
 
It’s been a while, I’ll need to pop the top off of mine. Have a swim meet to go too. Can it wait until later today?
First, confirm your wiring configuration.I remember the 220v version had 4 positions on the input side of the transformer. Going left to right I designate them wire position 1,2,3,4
If I recall there is a wire from the plug going to position 1 and 4. A jumper wire bridges positions 2 and 3
Correct?
More to discover