2. cables
  3. 130192-4374

Can upgraded power cords help my setup?

I have some KEF LS50 Wireless speakers and decided to use them with a Bluesound Node 2 via a Lifatec optical cable. Can I see a significant and worthy improvement if I swap out my power cords for something like Pangea cords? Do I need the AC 9SE MKII on the speakers or will the AC 14SE MKII be good for each speaker and also the Node 2 (C7?)? Power cords seem to be the only place left for me to tweak the most out of my setup.

Thanks for any input.
asahitoro
toddverrone's avatar
toddverrone
840 posts
 
@chewie70 - don't forget about cable geometry. That plays a part in the performance and 'sound' of a cable as well. Even power cables. 
williewonka
3,067 posts
 
+1 for @Toddverone point - the right geometry is an essential element in achieving the best performance from any cable - i.e. IC's, Speaker and Power.

Regards - Steve
randy-11
1,913 posts
 
be sure to use a geometry matched to the coriolis force vector for your latitude
toddverrone's avatar
toddverrone
840 posts
 
That was actually really funny Randy. C'mon though. There is loads of established theory regarding cable geometry and its effect on noise rejection, capacitance, inductance, signal integrity, etc.


randy-11
1,913 posts
 
why yes, and not just theory, but measurements

but....

the power cable goes to a transformer does it not?

the ICs don't matter

and the speaker cables depend on the complex impedance of the speaker with freq. - hence my usual advice to try 'renting' some cheap cables until you find what you like
More to discover