test it with a circuit analyzer, ideal industries 61-164
Quality of outlet not directly powering equipment important?
My new room that I have dedicated to music Has 5 outlets. They are all daisy chained around the perimeter of the room. They share nothing else on the circuit. From left to right of the room, the power goes from 1-5. The system is powered by outlet 4, which is an SR black. The house was built with very poor outlets, the kind that literaly bite down on the wire using a hole for insertion and a quick release tab, not even screw down terminals.
Upon seeing these POS outlets, which are in my "chain", I replaced outlets 1-3 with my collection of audiophile grade outlets. 1, with a wattgate 381 silver cryo, 2, with a teslaplex SE, And 3 with a furutech gtx-d (r). I did this to at least have high quality links for the Romex to feed the SR BLACK (4). I would assume that even with this "mix" of outlets in the chain, they must certainly be better than the absolute garbage outlets that were links in my electrical circuit. I would imagine less voltage drop at the very least.
Now, outlet 5 remains a contractor POS outlet. Its technically past the system, but being that this AC, and not DC, wouldn't it technically also be part of the AC chain feeding the stereo? Would it behoove me to change that one out even though it's past the stereo and not before the stereo?
Upon seeing these POS outlets, which are in my "chain", I replaced outlets 1-3 with my collection of audiophile grade outlets. 1, with a wattgate 381 silver cryo, 2, with a teslaplex SE, And 3 with a furutech gtx-d (r). I did this to at least have high quality links for the Romex to feed the SR BLACK (4). I would assume that even with this "mix" of outlets in the chain, they must certainly be better than the absolute garbage outlets that were links in my electrical circuit. I would imagine less voltage drop at the very least.
Now, outlet 5 remains a contractor POS outlet. Its technically past the system, but being that this AC, and not DC, wouldn't it technically also be part of the AC chain feeding the stereo? Would it behoove me to change that one out even though it's past the stereo and not before the stereo?
- ...
- 18 posts total
If at all possible, install 30A dedicated lines for your audio system. It may seem like overkill, but I noticed a significant lack of congestion when I installed a 30A capable power conditioner on my 30A dedicated line. Previously, I was using a power conditioner rated at 20A from the same manufacturer. Some of the benefit is certainly from newer technology, but the music doesn't sag when it becomes demanding. |
longplayer If at all possible, install 30A dedicated lines for your audio system.Installing 30A lines creates quite a nuisance because to do it and also be compliant with code means you'll need to install 30A receptacles. That means you'll need to either put new plugs on all of your components to fit the 30A receptacles, or you'll need to make 15A/20A to 30A adapters for each component, which is also a nuisance. A much tidier solution - and equally effective - is to install dedicated 20A lines, but derate the wire to 10AWG or better. That will let you keep the 20A breakers and use 20A receptacles, and will also meet code. |
- 18 posts total