The silver cap is either aluminum or metal, not sure. It has a silver paint coat on it. The caps overall depth is 1 inch. The upper part of the cap is 1/2 inch, the part that holds the arm, and the lower part is 1/2 inch. The cap is approx. same dimension as a golf ball. Golf ball is cut in half. The bottom part of cap is flat to fit cut golf ball. top portion of cap is curved, only for cosmetic reasons I presume. What you see at top of cap is not a set screw. It is just a hole which exposes a small portion of tonearm. Tonearm is just a tiny bit smaller than 1/4 inch in diameter. I would have to remove the arm to get an exact measurement. Would rather not do that for set up reasons as I have arm dialed in for my cartridge.
Well Tempered Simplex arm and wiring
Does anyone know who makes the 5 pin arm wiring connector on the Well Tempered Simplex table, etc? The pins are smaller than most 55 pin connectors I've seen. I bought a WT Simplex plinth (platter and arm were missing) and I am modifying it for use with a self-made Simplex clone arm.
- ...
- 32 posts total
- 32 posts total