12" Tonearms for TD-124


Finally having my TD-124 Mk ii
re-habbed as well as having a slate plinth made to accommodate both 9" and 12" arms. I'll be using my 3009 Series II and need to choose a 12" arm.

The 3009 will generally have MM carts mounted to it (V-15 iii, Jico MM-1, AT 155LC). For now, on the 12" arm I'm planning on using a DL-103r and eventually some type of Mono cart.

The Schick seems like a good choice mechanically and aesthetically so I'm currently leaning in this direction.

For some, either the SME 3012 or M2-12R might seem like an obvious choice. Have also considered the Jelco. No experience with any of the Ortofon arms.

Any insights or suggestions?


butch1970
If you lean toward the M2-12R, you might look further into the 3012R.  Before purchasing mine I probed the web and a few SME leathernecks who have experienced both an prefer the knife bearing and lower effective mass of the original 3012R.     
@dgarretson does it not depend on the cart that will be used? The OP stated that he will initially be using a DL 103R, which would seem to suit the higher effective mass arm better.
That's true, but at 14gm vs. 18gm for M2, the 3012R should be more versatile.  With a heavy headshell it should do a 103R.  With lighter headshells I've had good results from MM/MI to MC from Stanton 981LZS, Ortofon MC2000, AT ART7, AT33MONO, to Grace F10P.  One of my two examples has the German Analog Tube Audio silver rewire and RCA block.  It might be worth contacting him for an opinion about the two SMEs.
I spoke with Alfred Kayser about the 3012R vs the M2-12R and much of the discussion came down to the use of knife-edge bearings vs. race ball bearings. He thought the modern arm would have an advantage in this area.

Sound is subjective, though, and I can see how the 3012R might have some more versatility.

I already mentioned it in my first post, but the 9" arm that I'll be using is a 3009 series 2 non-improved that Alfred is going to go through and re-wire. Don't know if that would sway anyones decision on the 12" arm choice one way or the other.