Klipschorn Imaging

maybe the room needs a little treatment?

I have a pair in a room that enables me to have them snug in two corners.The toe-in created causes them to face in front
of my seating.They are also about 10 ft apart. They present a very nice sound stage.

I may be wrong but I am under the impression that imaging, at least in terms of 3-D soundstage is not the forte of the Klipschorn largely do to their corner location requirement?

I suspect Klipschorn performance in this regard may depend on what kind of imaging one is looking for? I also suspect the room is a major factor since placement options within a room for Klipschorn is limited.

If by imaging you mean more pinpoint location of recording elements between the speakers, then ICs and other tweaks might help.

It sounds to me like your placement is the problem. I had a pair set up properly (in corners)for years a long time ago with so-so ancillaries, and the imaging was fine. I don't understand how you are setting them up. You said that your room is 25x25, but the speakers are only 10 feet apart. How can that be? I'm thinking that your problem is related to positioning. Also, you may not like the look of a false corner, but corners are mandatory with these speakers, and if you can't or don't wish to use one, you probably should consider other speakers; perhaps Cornwalls.

Well, you don't have much flexability in positioning this speaker, to get stereo "Image" its all about acoustics and placement, and maybe more importantly in this case Position. Not only are you forced to put these in your available corners, but also the distance of those corners and where your seating position is normally is where it is and thats it. Not a ton of choice, this is why I believe ultimately many take K-horns and finally put false backs on them to simulate the corners which I guess you are doing as you say they are only 10 feet apart and its a 25 foot room?

Not everybody has the problem possibly, but obviously some of them do. It has way less to do with a magic cable, or source, or tube, or amp to correct this in most cases. Probably the only way to move this "Image" electrically without physically moving the speaker is to get the right crossovers that might open up and help the speaker more and I am not saying this will correct it, might just sound better. There is no right answer on that depending on the room and type of electronics used all add up to the ultimate results.

Room tuning could help if you can do it, I suggest some diffusors or something to try and break up the sound at the reflection points, but again this could be tuff if your dead in a corner somewhere with nowhere to place devices and treat it.
Good Luck