Seas Millennium Break-in time


Hi I just bought some new Tyler Acoustics Signature Monitors .The Seas tweeter is supposed to sound a little on the poor side until about 200 hours. Is this speaker(which is on it's way) really that bad until the 200 hour mark or is it not bad out of the box but improves some over the next 200 hours? How would you recommend breaking them in...playing them around the clock for 8 days at a moderate level or infrequently over two months or so...at a louded level? I am looking for a time & level that is best & what to expect out of the box. Tyler claims he player the speaker for 24 hours to ensure everything was operating properly.

Thanks

Bill
audiopath49
Bill,

My pair of Linbrook Monitor Signatures needed about 200 hours of high-ish playing levels to optimize, after which any additional changes were almost inconsequential. The Millenium tweeter is the most natural sounding dome-type tweeter I've found, so good, in fact, that I sought them out for subsequent purchases and now run two sets of speakers with them in two systems. Yes, they do roll off slightly but not at the expense of air, transient snap, and fineness of detail. Importantly, nor do they ever induce listener fatigue. The fact that they don't draw attention to themselves, yet pass all of the highest frequencies through, is too rarely achieved.

If you're having trouble getting in the hours you might try setting them up as monitors for your TV for a while...all depending on which media gives them the most play time in your home.
The used sig mons I purchased from Tyler needed to have new drivers and crossovers install .You recall I had some issues with over one being brighter & then some graininess overall .I discovered after blaming my tube amp that one crossover component may have failed making one speaker seem more brighter than the other then after a few days the system became raspy when turned up to moderate volumes which I think was one of the millennium tweeters being over driven as the crossover element became worse.The raspy desertion was quite noticeable & I sent the speaker back to Ty who was more than ready to fix it & send it back ….great guy.

In the interim I have noticed that although the other speaker sounded reasonably good that I twas a little on the hard side when pushed a tad and I am hoping that since he replaced everything that I did not get a group of bad crossover caps or something like that. It is hard to tell because by driving only one speaker, I may be overdriving it a bit to get the volume which is about half due to there only being one speaker.Hopefully it is just a case of driving the one speaker a little too hard & that when there are two I need only drive them at the 11AM not the 1 PM position to get a decent sound pressure level with the Portal..The whole system has sounded a but hard ,grainy in the mids right from the start & I queried Tyler(Mr. Patience) as to whether there may be mutiple issues with this new batch of crossovers however he maintains everything sounded good prior to leaving his plant as he played them for 24 hours so I need to take him at his word since given his stellar reputation & eagerness to help.If he thinks the other speaker is OK than it is OK .It is hard to tell anything I have found historically from listening to one speaker. & I have to trust a guy like Ty.
One online magazine(Stereo Times) reported that the sig mons were a liitle congested at higher volumes so I may have to live with moderate volumes with these. I have two amps a RA Tempest II tube integrated & a 100wps Portal Panache that kicks out 200 into 4 ogms both in good working condition now & my Creek CD50 MK II is quite new having all the most recent updates & sounded good with the RA & the Silverline 17V3.

Have others found?

A) the tweeter in the sigs to be on the fragile side perhaps even sounding a little hard if pushed & B) any fragility in these drivers including the crossover?. I would rather play them at moderate volumes & have them undamaged (even if very slightly) for 5 years rather than be subtly ruining the tweeter and/or crossovers by playing them a tad too loud since most of my music I play at low to moderate levels.

Any comments along these lines would be apppreciated.It is obvious that these drivers & crossovers are subject to damage on one level given Ty had to replace everything including the crossovers on this trade in pair….notwithstanding gross abuse of course.

I lived with the original Quad ELS for many years so I know what it is like to live with speakers with limited spl before they start to fall apart. The Quads were always good right up to about 90 Db in a reasonable sized room but as soon as you hit 91 you were in trouble & always needed to back off..I really hope I end up with a viable pair after all the time & expense I have spent putting this system together.

Again,your comments would be appreciated.

Thanks

Bill
My apologies for the poor grammar and typos.I have to take fairly large quantities of pain killers due to my illness. Some days are better than others & I am grateful just to have a little extra money to buy some of these products which in turn leds to endless hours of enjoying music.

Bill