which amp to upgrade my Levinson 383/39/WattPuppy6


hi,

i have a Mark Levinson 383 integrated, 39 CD proc, Wilson Watt Puppy 6, Transparent cable setup. my room is not is a fair size (22'x16' w/14' ceilings), but minimal rugs and lots of windows without curtains. the sound in this room tends to be on the bright side with all of the windows and no sound treatments.

even with the Levinsons, the sound feels a bit forward, almost bright sometimes, and i'm not getting enough "weight" in the bass (i seem to lose a lot under 30hz). assuming i can't do much with the room, what is the best way to help improve the sound. especially in the bass area. if i add a multi-hundred watt stereo or even mono-block amp, will this improve?

i prefer solid state over tubes, and mostly listen to standard cd's, mostly jazz, classical, house/trance.

i've been considering upgrading my amp (using the pre-amp in either the 383 or even 39) to a Krell FPB series, Classe CA-M400, Parasound JC 1, or Pass Labs 350. am i on the right track or should i be considering something else?

thanks in advance!

h
henrus

Showing 1 response by tommy

I find the synergy with harmon products to be very important. You may want to jump up in power. An inexpensive way to "try" this is there are usually many Proceed HPA 2 on the gon that you could buy for less than 1.5k if it works you can keep it or sell it and buy the more expensive Levinson piece. I had levinson front end and pass amps and sold the amps and stuck the Proceed AMP5 in to run the Salons and it matched up better than the X600s. It was going to be a short term solution and ended up being a keeper. Just my two cents.