What does Nominal Impedance mean?
I’m trying to decide on some new speakers (Clarisys Minute). They are rated at 86-88 sensitivity and a nominal impedance of 3.5 flat. Although graphs show it about 6 ohms from 20hz-500hz and at 2Khz and above about 3 ohms.
Turns out you don't need to know what Nominal Impedance is in this case as your speaker has essentially flat response of 3.5 to 4.2 ohm (based on youtube measurement of it). Normal speakers have wildly varying impedance with frequency so no one number ever represents its impedance. Your speaker is then is an easy load for most amplifiers.
Better yet, I have tested your Carver 350 amplifier with 4 ohm load. Here is its frequency response:
The amplifier has a peaking response with this type of load so may sound a bit bright.
You do have a ton of power available:
And even more for short periods:
So you can crank it up good, assuming the copious amount of distortion is not bothersome to you. In that regard, you are going to hear more of that distortion than your current, more sensitive speakers.
If you like, I can measure your new speakers. Start a conversation with me and we can take it from there. Good luck.