Grimace, I dunno if the OP plays golf, but his WT Classic is an older design and it
don't have no ball. ;o)
Pics of the Classic are around the Internet...
don't have no ball. ;o)
Pics of the Classic are around the Internet...
Well Tempered Tonearm Problem
Also...the original manual states that when set up properly, the arm should require absolute minimum anti-skate, as the silicone also prvides resistance to the arm wanting to move inward too. So, the thumbwheel should almost have those two arms together.....looks like mine has a bit over .5mm between them. Also note, I have had my WTT for over 20 years.....only recently noticed the teflon screw (and screwdriver access hole) in the back of the arm to lock in your azimuth.....so that the rear fishing line does not drop. Mine was always firm, so never realized it was there! When those are set up, your paddle should center. |
Note that you can buy turntables bearing the Well Tempered nameplate from two completely different companies. One is Stanalog, at the address Audiomax supplies above. They are the distributor of the successor to your Well Tempered Classic. The other is Well Tempered Lab. http://www.welltemperedlab.net/welltemperedlab/ This is William Firebaugh's current enterprise, the source of the new Well Tempered Amadeus series. Possibly you would have more luck contacting Mr. Firebaugh through them. However Stanalog may be able to give you all the help you need. |
I've had one if these for the last 15 years. If there is "way too much up down resistance" then the paddle may be too deep in the silicone cup. Bringing up both sides of the paddle will reduce the damping. The azimuth knob is not a friction fit. there is a set screw on the back. loosen it and pull out the azimuth knob. then you can slightly raise the other side(left, looked at from the front) via the small screw that holds the line from the left side under the azimuth knob. once this is done,replace the knob,tighten the set screw, and adjust azimuth.Repeat until you get the correct damping for your particular cart. Yea I know it is a pain but once everything is dialed in, things will stay stable.Oh, when an adj. is made you will need to wait 5 min or so for thethings to settle in the silicone.Remember the further apart the lines are the more antiskate.Closer,less antiskate. |