Short Power Cable (ie, 3 to 6ft)


I am planning to buy two Rowland mono blocks (model 6) to go with my Avalon Eclipse. This will allow me to put the mono blocks close to the speakers and hence it will be possible to use very short speaker cables. Is it advisable? say 3 ft!!

Any suggestion on the cables? (ie, MIT ?)

Your advise would be much appreciated.
vtin

Showing 1 response by gregm

Vtin, the sonic benefits of short speaker cable*-long I/C, versus short I/C-longer speaker cable, have been difficult to gauge in my experience. I have tried both -- the latter lately; my personal experience favours keeping the IC short (around 1m). This is probably because the signal from the pre is weaker than the one leaving the power amp -- and thereby more vulnerable to IC inductance?

Others, however have had good results with longer ICs & keeping the speaker cable on the short side... Could you not try both combinations before U settle?

Cable: I've never lived with an Eclipse/Rowland combo, so no suggestions, I'm afraid!

Good luck!

*(I assume that's yr topic -- not power chords)