2. cables
  3. 146899-2249

Replacing Alpha Core Goertz MI-2 Veracity Speaker Cable

I have used the Alpha Core MI-2 speaker cables in my system on and off for years.  It would be appreciated if anyone who has used these cables would provide the name and model of moderately priced cables that they have upgraded to and felt there was an improvement.  There is little about the tone or clarity of these cables I do not like.  Except that I just purchased a new amp and I don't want to even think of the possibility of it going into oscillation, even if it is remote due to the Zobel networks.   Prefer under $500 new or used for 10 foot pair.

Thanks
jetter

Showing 4 responses by ketchup

ketchup
688 posts
 
Sorry, I don't have any recommendations for you, but I use MI-3 cables in my system and my Classe CA-200 does not have any problems without zobels.  I bought a pair from Geortz just in case, though, and they were only $20.  Is there any reason why you think your amp will oscillate with the zobels?  What's the new amp?
ketchup
688 posts
 
That’s strange ketchup my ca200 goes into protection mode without the zobels.
That is strange.  Which CA-200 do you have?  The one with the heat sinks on the back or the later one with the heat sinks on the sides?  Which Goertz speaker cables do you have and what are the speakers?
ketchup
688 posts
 
Hi jetter,
You don't sound like a broken record at all.  I just installed the Goertz cables a couple of weeks ago.  I can install the zobels, but I don't see any reason to right now.  I never heard that an amp can be damaged slowly by using capacitive cables.  Do you have any references regarding that?  I was under the impression that if it doesn't work, it will be immediately apparent.  My amp runs nice and cool without the zobels and sounds pretty damn good, so I don't think there are any problems.  The Classe has protection cicuitry built in, so if there were a problem, I think it would go into protection mode as pop's amp does.
ketchup
688 posts
 
heatsinks on the back

@pops-  That might be the difference right there. My CA-200 is the later one with the heatsinks on the sides. My Magnepans are basically a resistive load, though. I’m not sure if that has something to do with keeping the amp happy with capacitive cables.

I used to own Thiels that I drove with my CA-200, but I didn’t have the Goertz cables back then!
More to discover