You can buy an "Oracle Maintainance Kit" for $150 that has new springs and washers and dampers and all kinds of stuff to update your Delphi...
It's well worth the investment.
It's well worth the investment.
Refurbish or Buy New Turntable
I have a question to put out to the forum. I have a Oracle Delphi mark ll turntable with an early Graham arm (Excalibur) and a Monster Apha Genesis cartridge (very low output mc .29mv). It has been in storage and I am ready to spin my vinyl once again. The table needs a belt and perhaps some suspension springs. My BAT VK 31SE preamp does not have enough gain to handle this cartridge and I was thinking of getting a higher output mc or a mm depending on compliance with the Graham arm.
My budget for the project is $ 1600 to $ 2000. In your opinion
will this old combination hold up against the new inexpensive table/arm combinations of today? Should I move on and look at Rega or the like combos?
Thanks in advance for any help!
My budget for the project is $ 1600 to $ 2000. In your opinion
will this old combination hold up against the new inexpensive table/arm combinations of today? Should I move on and look at Rega or the like combos?
Thanks in advance for any help!