Questions about Ethernet Cabling


PLEASE READ: This is not a thread about the merits or demerits of audiophile-grade ethernet cables, or any cable for that matter. If you don’t believe in spending extra on expensive cables, I respect your opinion but please don’t turn this into a point of contention.

So before I ask my questions, let me describe how internet connectivity is setup in my house:

- [Home office/study] The modem (AT&T), router (Google Nest/Mesh), and switch ($25 TP-link basic switch) are located in the home office/study. I also have a second system in this room as well as other stuff connected through the switch. In other words, I can’t move the switch to another room.

- [Media room] The main audio system is located in the media room which is in the diagonally opposite side of the house (single story). This room has the ENO ethernet filter connected to the Innuous Zenith MK3 streamer, and so on.

[Long ethernet cable] A very long run of ethernet cable (CAT 6/over 100 foot) runs from the [Home office/study] router and terminates into the [Media room] ethernet jack/wall plate. This was done by the builder and it runs through the attic.

- [Media room] From the [Media room] ethernet wall plate, I then use another 6 foot ethernet cable (also CAT 6) that goes into an ENO filter and then on to the Innuos Zenith MK3 streamer.

 

So here are my questions:

1. Is it worth upgrading only the so-called last-mile ethernet cable, i.e. the one between the [Media room] ethernet wall plate and Eno filter while I continue using the long CAT 6 cable [Study >> Media room]? It is going to be difficult, if not impossible, to replace the long-run CAT 6 cable as it goes through the attic where several spots are not reachable without tearing down some sheetrock.

2. Is it worth adding a second audiophile-grade switch (e.g. uptone) in the media room while leaving the one in the study as is? Or is it better to upgrade the switch in the study first and place the cheaper switch in the media room? Or do I need to replace both switches (not prefered as it adds to the cost)?

 

128x128arafiq

Showing 1 response by anzaanimalclinic

I have an Innuos Statement and as I understand essentially has a Phoenix built in.  Adding an ER was beneficial, as was then adding a SOtM  ngh10.  I agree the EE 8Switch was not as profound as the ER or SOtM but I keep it in the chain as does help.  Point is I found more is better than just one switch.  I essentially have four.

I have a Mutec REF10 clocking the ER and SOtM,  it lowers the noise floor significantly.  

I tried fiber between the SOtM and EE with a variety of Finisar's and felt it added digital haze in my system.  I am not convinced the sfp's are not noisy.  I would like to see someone develop an audiophile grade sfp, it seems to me there is a lot going on in that itsy bitsy sfp changing a digital signal to optical and then back. The sfp's were built for data just like most switches.