2. amps-preamps
  3. 126410-77682

How to do tubes up grade in a AR ref 1 preamp?

Wanted to up grade my preamp with all NOS tube but the original tubes was marked from V1 to V8 respectively to coordinate 8 sockets on the board.
After replaced with all NOS tubes, when cranking up the volume there was a distortion on one speaker.
what is the proper way to replace tubes? Anybody could help?
Thank you,
danon426
4 responses Add your response
infection's avatar
infection
805 posts
 
Which tubes have you installed? 
danon426 OP
1 posts
 
I have replaced all of the 8 tubes with NOS.
jmcgrogan2's avatar
jmcgrogan2
6,346 posts
 
It sounds like you have one (or possibly more) bad NOS tubes in that channel.

So, you have (4) 6922's in each channel, just go down the line and switch one set of tubes at a time until you find that the distortion switches to the other speaker. Then you will know which tube is the bad tube, and replace it.
noromance's avatar
noromance
9,413 posts
 
Or replace each tube on the bad side, one at a time with a good original tube. Power off for a few minutes between changes. Keep power amp volume low during power up and down.
Log in to respond
More to discover
80x80
Jeff Rowland Capri SC-S2
80x80
CH Precision P1 Phonostage
80x80
McIntosh MC275 MK IV