High End cartridges and the built quality


I had some cartridges in the past with some quality failure. Only one, an EMT was perfectly built.

Here some pictures of Lyra Skala and Kleos cantilivers/diamonds:

https://www.dropbox.com/s/qck7hep8ae12ay8/2015-03-06%2015.06.38.jpg?dl=0

https://www.dropbox.com/s/rgh6nefc6axwj91/2015-03-06%2015.15.13.jpg?dl=0

https://www.dropbox.com/s/kqe3cqruvtq128z/Diamant%20verdreht%20Skala.jpg?dl=0

https://www.dropbox.com/s/qxp5uhe4ek83xyh/kleos%20schr%C3%A4g%202.jpg?dl=0

https://www.dropbox.com/s/dxemuq8ehkilf82/kleos%20schr%C3%A4g.jpg?dl=0

I think in this price range not acceptable.

I know a Dynavector Xv-1s with the same problems.
128x128ninetynine

Showing 1 response by effischer

I had a pair of new Dynavector 17D3s fail due to quality issues. One was a cracked cantilever and the other was a failed internal wire at the contact pin. That failure wasn't isolated until the cartridge was one month out of the warranty period. Delicate electronics can fail, and DV understands that. They were very, very good about both issues. They offered full replacement or credit toward another model. Went with an XX2 Mk II and am thrilled with it. Major kudos to Mike Pranka at TOFFCO (the US distributor).

Lyra should be just as supportive as long as you purchased through an authorized retailer. Most high-end makers stand behind their products, so you should ask.

Good luck & happy listening!