Class A preamp or Class A amp

NOt exactly sure what your question is but the preamp will have the most effect on the sound.

Where do you live? I live in Phoenix. My Aleph 2s are Class A & I don't use them in the summer. I don't enjoy music with my heat pump cycling on & off......
A Class A pre-amp is not as big an issue - much less heat generated.....

It is the total design of the product. Some great products are actually Class A-B. Cello was an example of great A-B.

It is much easier for a company to make a preamp class A, than the amp.

Go by the sound, not the specs!

Richard
(I use only Krell class A.)

Thanks for your responses. As for Elizabeth, I was talking about the mode of operation. I have read that Class B or even AB has switching distortion in the transistor. In contrast, I have read that a well-built Class B can have two halves of the audio signal almost perfectly match just like it was operating in Class A.

The only class B stuff with "high end" aspirations I know of is Naim. Not my cup of tea.

So the answer is Class A preamp and Class A/B amp that stays in Class A for at least several watts. I use my pair of Alephs in the summer as they're suspended from the cooler ceiling joists just under the speakers, both to keep them and me cool!

Transistors need enough bias current to 'Wake them up' into their linear operating range. Higher bias levels will generate more heat and use more electricity. Since heat is the enemy of long life a cooler design may be wise.
Ron-C

I personally feel that your rig will be as good as the weakest link in the music signal chain. Two wrongs do *not* make a right in this hobby. To get the best possible sound, the "offending" component needs to removed totally & another better performing unit placed in there instead. There is no doubt that class-A pre & class-A power yields the most linear sound (I will not comment on 1 implementation of class-A vs. another) & if you can afford it as a *total* solution, then get that. Total solution includes electric bill for AC power & cooling. I have found that if the designer has decided to make a class-A amp right from the get-go then heat sinking is very well thought of rather than being an after-thought. Still, good ventilation is a requirement by the end-user.
Next best would be class-AB that are biased towards class-A for their initial watts such as Pass, Symphonic Line, Odyssey Stratos just to name a few I'm familiar with.
I quite certain that each piece in the music signal chain affects the overall sound. So, you decide where you want to compromise but don't let anyone tell you one piece has more or less effect than the other!
FWIW. IMHO. YMMV.