CD player vibration control ..................

I use German Acoustic tonecones. I put three in a pyramid configuration on the bottom and on top 1 on each corner of the CD player with the spike up.I then tighten each cone until the spike is going into the componenet shelf above the one it is sitting on and I use a level bubble to make sure it's dead nut level. I've done this with most of my components and it works like a charm.

If you read my post that is how i isolate the transport part of my CD player. I took a cigar box and filled it full of sifted sand. I then cut the lid so it sits on top of the sand but is a 1/4 inch from the edges of the box and placed my dual mono outboard power supply on it. I then placed a VPI magic brick on top of the power supply. I use this for my second system since I just purchased a Sony/Modwright player. Haven't had a chance to size up this player yet but will come up with something. Total cost of isolation = 80.00 dollars.