I looked up the recommended distance from the back of the speaker to the wall behind it and magico has it at 20 in. Yours are at nine inches this could cause bass issues and also affect your mid-range. I would also put a level to the top of your speakers to make sure that they are perfectly level. Also distance measured between speakers should be from the Center of the Tweeter to the Center of the other Tweeter. Make sure your measurements are exact. Once you've got the speakers to your liking I would call gik acoustics, and give them your measurement stats, and describe your sound issues, than ask for their recommendations 4 acoustical treatments. Best of luck
Adjusting speaker positioning. What, if anything, to expect?
I am going to adjust my Magico A3’s positioning a little bit to try to optimize their performance and the listening experience. Due to the logistics of the room they’re in, there’s only a limited amount I can move them. I’ll describe the room and what I can do within those limitations. I’m wondering what improvement I might be able to achieve with adjusting positioning.
The room is approximately 14’ x 22’. There is a high vaulted ceiling. about 15’ at it’s peak centered in the room on its horizontal axis. Picture how kindergarten child draws a house. That’s the shape of a cross section of the room and vaulted ceiling.. The speakers are located about 8’ apart centered on the long wall. The front of the A3’s are only out 22" from the wall, the rear of the speakers only 9" from the wall. That can’t be helped. The prime listening position is on a couch about 10’ out from and facing the same wall, also centered. The components are on shelves centered and built into the same long wall the speakers are on. There are some other furnishings, and books above built-in cabinets, line most of the other three walls.
I can move the speakers about a foot farther apart or closer together, and I can change their toe-in. What changes, if any, might I be expecting or hope to achieve moving the speakers within these limited parameters? Could the sound-stage be affected? I’m not sure what the sound-stage should be like anyway. Should it extend to the left or right outside the speakers, or be mainly between the speakers? Right now depending on the recording the vocals and instruments are usually between or no further apart than the actual speakers. Could the treble, midrange, or bass response be augmented or diminished depending on positioning? Are there any other factors that may be affected by positioning alone? Thank you for any guidance and please feel free to ask any questions. Thanks,
Mike