BI AMPING

Jsman, i bi-amp and for various reasons it seems right for me.

bi-amping is when you are using 4 channels of amplification for stereo instead of two channels.....it could be one amp with 4 channels, 2 stereo amps or 4 monoblocks. i assume that your speakers have two sets of speaker terminals.....one for the midrange and tweeter and one for your woofer.

bi-wireing is when you use two sets of speaker cables out of one amplifier. these two sets of speaker cables are connected to two different sets of binding posts on the speakers.

it would help to answer your question if you could explain the context of your system. which speakers, ampifiers, preamp and size of room......as these things affect what the best approiach might be.

you mention active xover; do you now have one or are you considering one? this direction is a whole additional issue. the whole connectivity question depends on your system configuration......are you running a single set of interconnects out of your preamp into this active crossover or are there two sets of preamp outputs on your preamp so separate sets of interconnects can be run to all 4 channels?

in general; you want the same amps for all 4 channels and the same speaker cables but beyond that there are lots of considerations and viewpoints on the best solutions.

Mike,
My system includes, Sophia Electric 300b MKII power amp,
which I want to use on my tweeters and mids. Pre Amp Rogue
Audio 99 Magnum, one set of pre outs. Marantz 300DC power amp, which I want to put on the woofers. My confusion is about the active xover. Can you help? I do not have one yet.

Jsman, thanks for the info. please tell me what speakers you have and the approximate size of your room.

using an SET amp combined with a solid state amp will be tricky...but do-able. there are many that do take that approach.

personally, the approach i might take would be to use some sort of 'Y' splitter with one amp simply attenuated with a passive volume control such as the Placette RVC which will be transparent in the signal path. this would be much simpler than any active crossover design and with amps of that level you will hear it. an outboard crossover can yeild some advantages by not sending the entire bandwidth to the SET but IMHO at too great a price (both $$ and sonically).

there are impedence issues which are beyond my personal level of expertise that you could run into when using a splitter and a passive attenuator.

your amps are both quite special and if properly combined should sound great.

maybe someone with specific SET/SS biamping experience can chime in with other suggestions.