2. analog
  3. 1369685138

Where is my problem ?

I have a Transrotor Fat Bob TT with a Graham Phantom II arm and a ZYX Airy3 cartridge which is set up as well as I know how. My LAMM LL2 has dual volumne control so when I turn down one channel vs the other the left sounds slightly more congested or not quite as sharp and clear as the right especially on say, a trumpet hitting high notes.

Where is my problem likely to be? The Phantom lets you adjust lots of things like Azimuth, VTA, anti-skate. These are at the recommended settings. I've tried adjusting these but can't get the sound fixed.
128x128jyprez
jameswei
883 posts
 
Is it in the recording? Have you tried different music?

A good way to identify the source of the problem is to try switching left versus right channel connections.

Once you identify the component that is the source of the problem, you could see if it is defective or only incorrectly adjusted.
zd542
5,339 posts
 
Jameswei is right. Also, there may be no problem at all. If the image of whatever you are listening to is not exactly center, then the volume/loudness will be different for each channel. For example, if the trumpet you are listening too is to the right of center, then it should louder in the right channel.

Its also possible that the volume pots need to be cleaned.
newbee
4,751 posts
 
Try switching the tubes from channel to channel on your pre-amp. It's possible one of the tubes is responsible for your problem. If after you switch the tubes your problem remains in the left channel at least you will know it is not the tubes in the pre. BTW, I thought the Lamm was a line stage, what are you using for a phono stage?
marakanetz's avatar
marakanetz
5,473 posts
 
Sometimes newer vinyl of the same recording fixes the problem too. Maybe this vinyl had been played too much.
manitunc
795 posts
 
Do you have a fozgometer? with it, you can easily check to see your channel balance and crosstalk and adjust azimuth to reduce crosstalk between channels.
More to discover