Passive Preamp works with Dynavector p75?

It will probably work, but how well is the question. Input sensitivity of .8V is a good start, but the gain level has to be taken into consideration too. Also, input impedance on the amp is 10k ohms, not usually ideal for a passive preamp regardless of the source IMO (unless it is a buffered passive like the Pass B1).

>You will probably be surprised by the increase in clarity and refinement, but very possibly also disappointed with the lean and undynamic sound<

If he goes with a transformer or autoformer type passive he won't be disappointed. They don't have the issues with dynamics or leanness that you speak of.

Shakey

Thanks everyone. So may be I should connect the p75 directly to the Mac and see what happen. Now my question is: Are you sure it won't damage my speakers because the output volume is too high?

The MC Gold has an output of .4mv. This combined with the P75 gives a total output of just 575mv.

That is not the maximum output, it is the output with a standard test track. The maximum is higher so it could well be that it will drive an amp with .8V sensitivity to clipping especially on a hot record.

You also need to be concerned about the low input impedance of the amp. If you get a typical passive with an impedance of 10K or so the phono stage will see that and the 10K of the amp in parallel for an effective impedance of around 5K at higher volumes. I couldn't find a spec for the output impedance of the phono but it it is on the high side, say >500 ohms your sound will suffer.

.