Higher power=better sound at low volume?


I have heard numerous times that the more powerful the amplifier, the better the sound will be even at low volumes. If this is true, I assume it only holds true if you are comparing apples to apples so to speak meaning 100 Krell watts problably sound better than 200 Rotel watts through the same set of speakers. But if you are comparing apples to apples, is this true? If so, this should justify more powerful amplifiers, perhaps above and beyond the power rating of the speakers, for someone who only listens at low volumes. Is this true? Is this true only for certain classes of amp, A vs AB VS D, ETC. or is this a myth?
Thanks for any info

thus making a really powerful amp useful even for people that don't listen at loud volumes.
bsooners
All other things being nearly equal ( often the case in SS amps ), 200 watts power is usually better than 100 watts as it will be less likely to clip as source material becomes more challenging. A doubling of power is usually required to make a perceptible audible improvement.

Transients in music can be challenging even if the average sound level is quite low...this is why a more powerful amplifier or an amplifier with more transient headroom can be better even at low levels.

An inefficient speaker with a difficult and bumpy impedance curve can also complicate matters. Amplifcation needs to be appropriate for your speakers. Damping factor is usally higher in bigger amplifiers...this will better control your drivers and reduce distortion.

A small amplifier when overdriven can destroy speakers many times the rating of the amplifier.
Speaker efficiency must play a part. If you get 90 db from your first watt and 93 from the second watt, 96 from the 4th watt and so forth, how much power will be needed for low level listening? So I agree with Elizabeth. My speakers are 101 db efficient and sound very dynamic even when played quietly.
I like Albertporter's theory.

Go to a hi-fi shop and take a resolving pair of bookshelf speakers.
Set them up with three different amplifiers at about 50w, 100w, and 300w.
Assuming they are all quality amplifiers there will be an appreciable difference in sonic characteristics.
Chances are the more powerful amplifier will be more dynamic at low volumes though.
Not necessarily better; just different.
Matching an amplifier with a speaker (and preamp, and source, and ROOM) is time consuming.
Recall buzzword "synergy."

Good luck!
Several factors come into play, both on the amplifier side and the speaker side.

The amplifier's distortion envelope is very important. Large amounts of second harmonic distortion are inaudible, but very small amounts of high order distortion can be quite objectionable. And a type of distortion called "crossover distortion" that occurs at the zero point with class A/B amplifiers is particularly nasty. Its usually masked at medium and high power levels, but is unmasked at low volume levels. If an amplifier's distortion rises at very low power, that's likely a sign of crossover distortion. Class A amps are free from crossover distortion, as are Class D amplifiers, and of course some Class A/B amplifiers are better in this area than others.

As you can infer from the above, loudspeaker efficiency can come into play. If the speakers are high efficiency and the amplifier suffers from crossover distortion, then the amp is more likey to be used at very low power levels where that distortion is most audible. This is probably one of the main reasons high efficiency speaker owners prefer single-ended triode amplifiers, as they are inherently Class A and free from crossover distortion, which under the circumstances would be far more objectionable than the high second order harmonic distortion they do generate.

Also, if a loudspeaker has drivers with significantly differing power compression characteristics (meaning they don't all increaase in loudness at the same rate), then the system has probably been voiced to sound right at medium to high volume levels and will have a tonal imbalance at low volume levels. Usually the tweeter compresses less than the woofer, so most common is a speaker that sounds dull at low volume levels and overly bright at very high volume levels. This is less likely to be an issue with high efficiency loudspeakers, and is a non-issue with single-driver loudspeakers.

Finally, I have read that some woofers have suspension systems that are non-linear at low power levels and so the bass is weak at such levels. Frankly I think it's more likely that weak bass at low power levels is a function of the ear's reduced sensitivity to low frequencies at low volume, but wanted to mention it just in case. Rubber surrounds are most often accused of being non-linear at low power levels.

As long as an amplifier isn't driven into clipping, I don't think it's how powerful the amp is per se that will make the most difference in its low-volume-level performance.

Best of luck to you,

Duke