Kl Audio LP200 ultrasonic record cleaner insights


I did a bit of research a few months ago on the Audio Desk ultrasonic cleaner and thats where I found out about the KL Audio CLN LP200unit. I was attracted to the much more powerful motor, no rollers to replace and using distilled water rather than a cleaner.

Let me start that I have a Loricraft and used the Walker 4 step program but shortened it to a clean\rinse setup. Still ten undivided minutes of your time a side to clean. After a while I didnt bother with mint or new records.

Table Galibier Gavia, Triplanar Arm, Zyx Universe cartridge

I have quckly and efficiently cleaned more records in 3 weeks than I have for the three years I have had the Loricraft. And it was hardly an inconvienance, not a major chore

I have cleaned a number of Walker\Loricraft records again with the KL Audio. The results are jaw dropping. Dead quiet, no static pops (sometimes dont even zerostat). The biggest issue is resolution, getting down and removing that last bit of material and the resolution, body, separation of instruments, timing, passion and air around the notes is enhanced. Modest pressing sound like audiophile. I have ran into a few noisy records, probably dug out by the last stylus but most everything else has been so overwhelming. Low level detail is to die for.

The machine is a tank. Everything impeccably manufacturered. You can set the ultrasonic to 1-5 minutes and the drying 2-4 minutes I spit out a record every 5 minutes while I watch tv from the next room. It drys very effectively but isnt that loud

This machine is not cheap at $4k but what it does is like a very serious component upgrade. Highly recommended for someone with a serious vinyl collection and setup
128x128audiotomb
$4000 is a chunk ofmoney to me BUT I will be getting one of these when funds are acquired. I do not have any hesitation whatsoever. Currently using a NG MiniPro2 RCM.
I bought one of these recently too. Haven't used it much yet but waaay easier to use than a VPI. set it and walk away. Record surfaces are pristine when you hold the LP up to the light. Sonics much quieter.
I bought a KLaudio earlier this year and I can't say I have experienced it’s superior cleaning ability as all of you have. When the first unit arrived, I followed the instructions carefully and filled it with distilled water. A few moments later I stepped into water on the floor, then I noticed that everything on the kitchen counter was soaking wet. I took the unit over the kitchen sink and notice it was leaking from the reservoir screw. I tried to remove the screw but to no avail. I took it back to the dealer. Several weeks later a new KLaudio arrived. This times no leaks. I have done before and after cleaning tests with KLaudio vs Spin Clean vs Nitty Gritty vs Manual “under the sink “cleaning; and I can't say definitively that Klaudio is superior. In each test case, after using the Klaudio, I still hear the clicks and pops just as before. Klaudio did not make a difference to me. I conducted each test with records that has no visible scratches, and was previously cleaned. I also tested records just purchased from the used record store. Still could not hear a difference using the Klaudio and the other cleaning methods. I also examined the Klaudio carefully to see if it was making bubbles in the water. I noticed that the bubbles were only on the left side of reservoir (facing the Klaudio), I don't know what that means. Please look at your Klaudio and tell me where the bubbles are concentrated.
I am not knocking Klaudio, I am just stating my experience. I will continue to use it and see if I am leaving out something.