Bi-amp a two-way speaker makes sense?

Not exactly what Jsawhitlock sais:
If you have a two pair of binding posts on each of your speaker and if you will feed each input of amplifier separately i.e. using y-connector that you will have two separate amps amlifying the same signal and so you will increase the output power.
I did it a couple of times when I had to fix some of the amps: one was Nikko Alpha 200 and the other was AudioREsearch D100B. As you may check my system I still have my Totem Forrest 2-way speakers... Both of these amps have approximately the same gain as my VTL MB100 tube monos and I was amazed how SS and tube together could sound much much better than each one of them separately alone!
I have in my arsenal a DIY stepped volume controll boxes that I could apply to tame the higher gain amp and adjust tonal balance.

I would rather bi-amp than having to sell my current amp
to buy a more powerful amp. I think mine is not bad at all
and I probably have to spend about double to get any meaningful improvement. My amp only gets a touch harsh if
I drive it beyond 85% point and it well may be the fault of my CD player since I am using a Nad541i.
The reason I ask first before actually committing to bi-amping is that if I decide to bi-amp, I have to
modify my current speaker cables and purchase a pair of
Y-connector which requires some financial investment on
my part.
I am using Van den hul D102 MKIII interconnect. Do I have
to use a Y-connector of the same type? Could you recommend
one?

I would think bi-amp would increase power, if not doubling, since the woofer and tweeter will each potentially receive 125W exclusively to themselves instead of sharing a single 125W source.

Anyway, these are my opinions.

Andy

Audio Refinement makes (or at least made?) a two channel amp @ 125 watts per. What do you use the extra channels for at this time? Do you have HT or multichannel music? If you do..then I would just pick-up the two channel version of your amp and use it's channels in the bi-amp. Of course if your not using the extra channels you have now for anything I can understand were your comming from with wanting to get some use out of them.

Dave

I would certainly try the biamping. In addition to probably getting more power, you're reducing feedback from woofer to tweeter and vice-versa.

Richard

I am actually using the amp in a HT configuration. But I can always buy a less expense 2-channel amp for the rear if
I decide to bi-amp. Thanks for your feedbacks.