2. speakers
  3. 1077223332

Replacing the stock jumpers on my B&W's

I need some help. I'm trying to replace the stock jumper plates on my CDM9's. I have some left over OFHC speaker wire that should work well. I'm currently using banana plugs into one set of terminals now from the amp. Bare wire won't work. The screw down terminal nuts aren't wide enough to hold the wire. I want to use spades. Problem is I can't find any spades that fit the binding posts. I believe the binding posts are approximately 7/16" or 11mm wide, fatter than the 3/8" spades that I've found so far (kimber and others). Anyone have any ideas? I don't want to biwire the speakers.
hammergjh
hammergjh OP
157 posts
 
I may be totally wrong but....

The gap in the stock jumpers measure 5/16". So I was probably incorrect earlier (I posted this from work). I recall trying spades that were 3/8", and they didn't fit. Hmm... Now I'm confused. I can't use the wire holes in the posts because the banana plugs get in the way. I tried the Kimber spades (10 bucks a pop, so 8 x $10 is way too much) and they didn't fit w/o really forcing them on.

Back to the drawing board. Jeez.
stanwal's avatar
stanwal
3,147 posts
 
Mapleshade makes some flat jumpers that are available in custom lengths and are reasonable in price , look at their web site.
hammergjh OP
157 posts
 
I decided to go with Stanwal's suggestion for the mapleshade jumbers. 23 bucks delivered for pure copper ribbons. Too cheap to pass up.
More to discover