Non-Latching or No Latch Female XLR Connector

My Mackie Onyx 32.4 has no-latch XLR chassis receptacles too(28 females). Some Neutrik chassis receptacles have a spring retainer, instead of a latch. ie: (http://www.neutrik.com/en/xlr/a-series/nc3fah-0) If you can see the locking window(slot) in the male IC plug, you should be able to depress the spring with a small(jeweler's type) screwdriver, IF required. It's supposed to take 14.75lbs/ft(20N), to pull the plug from a(Neutrik) receptacle(without a screwdriver). IF NOT; Mr G offered good advice, regarding the manual/contacting the manufacturer. I've never seen a twist release, 3 pin XLR, but- I supposed anything's possible.

Thank you Rodman99999. Yes, I can see the spring retainer but can't press the spring from outside the box. I opened the cover of the gear and was able to press the spring retainer from inside.

My fundamental question is what is the benefit to install such inconvenient connector. Also what would be the long term solution to this kind of connection.

Thank you Guidocorona as well. But I don't have guts to try that way as I have very clumsy hands. I twisted the same IC cable (Stealth) three times already.

I can't think of a benefit, unless the equipment/cabling was in a location that allowed for tampering. The solution would be to replace the chassis receptacles with the latching types. Personally; I would choose from those with either silver or gold plated contact points. ie: (http://www.neutrik.com/en/xlr/xlr-chassis-connectors/a-series/) (http://www.neutrik.com/en/xlr/xlr-chassis-connectors/d-series/) (http://www.switchcraft.com/productsummary.aspx?Parent=476)

Actually I am a little disappointed in this machine with such connectors as it has a 5-digit price tag on it. I checked the prices of latching and non-latching connectors, the difference is just within $2. It has only 3 such connectors so the total cost difference is under $6.

For a machine targeting 5-digit market and having such inconvenient design is not well designed.

Thank you so much for your inputs and suggestions, Rodman99999.

Happy Listening!

Otto

Hi Otto- I do agree that those receptacles would seem an unnecessary inconvenience. If you are pleased with the unit's presentation, it's might worth converting. Not really much in the way of expense and an easy swap(if you can solder). Then again- How often will you be changing ICs? Now that you know the trick(re: disconnection); Do you really need latching connectors? Enjoy your music!