Is there a list of cartridge capacitance?


My phono stage has various cap values, but I can't see the cap value of my cartridge(Clearaudio Talisman V2 Gold)anywhere in the literature from Clearaudio.

I do have the cap value for my tonearm cables,28pf/ft.

Has anyone found a list of cartridge capacitance that I can use to properly set the values on my phono stage?

Please,I've done enough experimenting, and the answer is there are numerous settings that "sound good", I would just like to confirm if what sounds good to my ears jives with what is prescribed to sound the best vis a vis the correct match up of capicitance between cartridge and tone arm wires.

lacee
Input the resistance and inductance for your cart, and input capacitance values to see what the resonant frequency is. I think anything above 20 KHz is fine, so capacitance values up to that resonant frequency should be OK.

Yikes! When you are dealing with LOMCs, there is no need to add any capacitance for loading! That has entirely to do with high output *moving Magnet* cartridges, where loading the cartridge does have an effect at audio frequencies.

By adding capacitance to a LOMC, you move the RF (Radio Frequency) resonant frequency *down*, but not likely into the audio band. The inductance of such cartridges is tiny, so the RF resonant frequency is going to be high. In any event, you will have to kill that resonance with a resistor, not a cap. IOW by adding capacitance in effect you have created a bit of a moving target.

Raul is correct, any amount of loading capacitance offered by the phono section is inconsequential at audio frequencies. It can have a huge affect at RF frequencies though; its the ability of your preamp to handle RFI (Radio Frequency Interference) that says how audible the loading is: the more RFI bothers your preamp, the more important you will find the loading.