Pop heard when stylus dropped into lead-in groove


I'm not sure whether I recently developed this problem or if I just didn't pay it any mind before. However, now that it has entered my consciousness, it has become a constant source of angst. I have checked anti-skate, added damping fluid to the well (Aries II), cleaned the stylus. I'm at a loss. I have an Aesthetix Rhea and admittedly it is a high gain phono stage which has a tendency to accentuate pops and clicks. Is this phenomenon normal? Is it a possibly a sign of stylus wear? Once the music starts to play, there are no problems with tracking, distortion,etc. Could it be the blunting of the stylus is magnifying the impact of the stylus as it navigates the transition from the lead-in groove to the recorded portion of the record? Assurances welcome.
128x128stew3859
Post removed 
Ah. To mute or not to mute, that is the question...

I, too, am an unmuter. I like to know where my tips going.
I have friends that mute like there's no tomorrow. I just dont see the need.
Now if several are cueing during the same listening session,
It could be wise to mute for various unbeknownst volume settings.
The loud pop comes from the high forces deflecting the cantilever when the stylus is dropped into the groove. It is exacerbated by a number of factors. First, one must cue the down the arm slowly to minimize this force. The pop can become more of a problem if the cuing rate has changed (most cuing devices use viscous dampening and the tendency is for the drop rate to increase as the mechanism ages). If your arm does not allow for an adjustment to the drop rate, you will have to lower the rate yourself by slowly moving the lever each time you cue.

Sometimes the rubberize bar that holds the arm in place becomes less tacky which allows the arm to drift out of line when it cues down. If your arm provides antiskating, this causes the arm to drift outward toward the edge. If the arm cues too far out toward the edge of the record, the stylus will land on the high edge bead. The arm/stylus will then fall downward to the lowspot inside of the bead; this fall and abrupt stop is often the cause of a loud pop. Try cuing the stylus further into the record to avoid hitting the outer bead.

Slower cuing and cuing far enough into the record to avoid the outer bead is usually enough to minimize any sort of loud pop.
I discovered the culprit. I had the gain set on my phono stage (Aesthetix Rhea) to the highest setting (75). I don't remember going there, but perhaps I was experimenting and forgot to return it to where I normally have it set (62). I also had my VTF tracking at the high end of the recommended range, so I scaled that back slightly as well. The combination worked to amplify what we all hear as normal to the point where it sounded like a static charged particle. I still hear it, but it no longer draws attention to itself. Its nice to "fix" things for free.
Hi Stew. glad that everything worked out. FWIW, that's why I mute my phon stage.

My gear includes an ARC Ref3 line stage and an ARC PH-7 phono stage. The PH-7 does not have a gain control -- instead, it's gain output is set to full throttle. By contrast, gain control is handled exclusively through the Ref 3. Ergo why I mute the PH-7.

Hence, if my stylus "pops," I don't want full throttle gain going through the amplification circuits of my PH-7. I have no idea what if anything could happen if there was a transient overload (pop) -- and I don't want to find out. Similalry, I don't want that type of transient surge amplified through the rest of my rig and ultimately into the speakers. It may (??) do no harm, but I can't see how it can help anything -- unless I want to scare the sh*t out of the roaches and rats. So, for all these reasons, that's why I mute my phono stage everytime I play a new record. FWIW.