Which Pre Phono between Dynavector XX2 and AN M3


I do not have any Phono entry on my Audio Note M3 pre-amp and want to buy a Pre-phono + step-up for my Dynavector XX2 (mounted on Regar Arm and DSP Turntable).

I'm hesitating between:
- EAR 834P
- Aqvox 2CI MKII

but open to better choice ..

Any advice or experience on that ??
stelma
Personally, I prefer the Vacuumstate JLTi and Pass XOno to the EAR and AQVox by quite a bit. The JLTI and XOno do have so much more detail and dynamic compared to the EAR. I fell the EAR would be holding back your otherwise excellent analog set-up.

I assume you mean a DPS table? What is the rest of your system like? If you need a richer sound, I would consider other tube phonostages like the Herron, Art Audio or the K&K instead of the Ear.
I'm going to go out on a limb here and say the Ayre P5xe may be the best at anywhere near this price point(and much higher). First of all, I'm not a P5xe owner(GCPH) but I've been researching phono stages for a couple years and it seems the only one with close to everything you need in a phono stage.
-Adequate gain for any cartridge
_quiet operation
-potential for balnaced and single ended connections(in and out)
-loading options(it falls down a bit here in terms of convenience but there is a wide variety of options)
-RIAA accuracey
This last point is the most frustrating for me on even mega expensive stages. Take, for example, the $12,000.00 Audio Teckne currently highly touted by TAS and sure to have a glowing review coming soon. RIAA on this unit varies by +-1.5db. Doesn't sound bad at first but this is huge. By comparison, the $2500 P5xe varies by only +- .05db. My GCPH, also dead quiet and very flexible, +-.1db.
For these reasons, I would recommend looking more closely at these two moderately priced units. More money may get you less flexibility and more coloration and not much else. Need more than one phono input? How about 2 or even 3 P5xes. You still come in at less than a megabuck phono. Anyway, this is where I've ended up so far. I feel the P5xe is vastly underestimated because of it's modest price. Of course YMMV.
Sonofjim, hsince you brought up the RIAA accuracy:

JLTI +/- 0.1dB from 10Hz to 50KHz
XOno +/- 0.1dB from 20Hz to 20KHz

Not like I think this is the only important parameter though...
>>I'm going to go out on a limb here and say the Ayre P5xe may be the best at anywhere near this price point(and much higher).<<

I agree.

You are going out on a limb.