2. analog
  3. 1210395585

Rega RB300 Troubleshooting

I recently upgraded my RB300 tonearm with the incognito rewire kit and have learned from experience that it would have been better to have this done by a professional (especially since I've just voided the warranty). It was extremely difficult removing the rubber boot that housed the cartridge leads especially since the instructions said to push it INTO the arm tube!! What I ended up doing was removing a small, critical screw from the tracking force adjustment knob by mistake that I can no longer screw back into place.

Basically, my question is what are my options? I have no idea how to get the screw back in and wind the spindle back to it's original position. The knob was set to 3 when I removed the screw. Other than this, the upgrade went smoothly (even the soldering).

Any help greatly appreciated!
hitman_hifi
2002ss335
84 posts
 
My tt came with a rewired RB300 arm and when I set it up I could not get the VTF adjuster to do anything. So I used a scale (which I think is better than using the adjuster).

I got ahold of the seller and was told that the spring was removed to reduce vibration. That was six months ago and I just keep using the scale to set VTF no problem.
hitman_hifi OP
75 posts
 
Pops -> there is a small hole but it only holds the screw temporarily. When dialing the plate back, the spring will eventually pop the screw loose. I'll probably have to get a VTF gauge.

Onetwothreego -> What's the procedure to get the spring out? By the sounds of it, the VTF adjuster doesn't seem to be as critical as I thought.
onetwothreego
54 posts
 
>>Onetwothreego -> What's the procedure to get the spring out? By the sounds of it, the VTF adjuster doesn't seem to be as critical as I thought.<<

Cutters. Snip.

You will actually find it sounds better with it gone once you get your VTF gauge.
hitman_hifi OP
75 posts
 
Well I got the spring-coil out of the knob. Thanks to TNT I found this pic.
Unfortunately, the tonearm is out of balance (insert angry face here!!). The counterweight has to be pushed way back, with about a quarter of it hanging off the edge, to get the arm floating again.
rccc
216 posts
 
Get a heavier underslung weight then your upgrades complete.
More to discover