Good way to dampen tonearm?


I am in the process of replacing the stock Klotz wiring harness in my Rega RB-900 with the single-piece "Incognito" wiring harness. I have been thinking about adding some damping material inside the tonearm tube, and considered trying a couple of shots of expanding insulation foam.

I'd appreciate comments about the wisdom (or lack thereof) of the foam treatment idea. I am concerned that the chemicals in the expanding foam might be bad for the dielectric on the very thin Litz wire inside the tonearm tube.

If anyone has any ideas, or personal experience, with ways to dampen arm tubes, I'd appreciate getting your commentary.
sdcampbell
There are a couple of inexpensive ways to dampen your tone arm that are easily reversable. One is to wrap the arm tube with plumbers teflon tape. Simply wrap the entire arm, or alternately, two or three spots with multiple layers of the tape. Another is to purchase some shrink tubes from Radio Shack. These are 4" long plastic tubes that can be slipped over the arm tube and shrunk snugly onto the armtube by gently heating them with a hair dryer. Either of these techniques will have a dampening effect and you can decide whether or not you like them. If not, simply remove them and you'll only be out a few dollars, at most.
Finally, Herbies Audio has HAL-O JR dampers that might work as well and if you don't like them just return them for a refund: http://herbiesaudiolab.home.att.net/jr.htm
Why not dampen it with something from the outside instead of the inside? I remember a local audio dealer that did this with a Well Tempered table (not sure of the arm). He had it wrapped just as you would re-wrap a tennis grip. It was a rubbery material maybe 3 millimeters wide. I'm not sure what it was exactly, but this is certainly an idea to explore. Good luck!
I successfully dampened (wrapped)a tonearm using tiny foam wrap tape that was either from the dental or medical industry. Internally, the foam earplugs seem to be a good shot.
Oh yeah, I forgot to mention I experimented with various shrinkwrapping on the arm also. It is good as it is easily removed.
Some shrink tubing has glue on the inside that is activated by the heat. If you try that make sure you get the kind without glue. It would also be hard to cut off without scratching the arm.