Cartridge Setup Question for Rega P10 with Hana Blue

Thanks and I agree -- I did pull the trigger and order the Rega SS shim. I was just wondering if a wedge shim between the cartridge and tonearm to realign the angle was a preferred solution to adding a shim between the plinth and tonearm. Especially since Rega is silent on recommending the shim for the R3000  Tonearm.

... I'm sure I'm just overthinking it. They are probably just being silent on a shim for the P10 to encourage sales of their higher end cartridges. 

@mikei I just installed the Rega 2mm stainless shim under the TA2 tonearm (a modified Rega RB330) on a Michell Engineering TecnoDec.  It would have been easier to use washers or the two-piece kit from Acoustic Signature, but I wanted to use the official Rega part (call me crazy).  It's a bit more work to undo the ground wire from beneath the turntable and completely remove the three bolts securing the arm to the armboard, then pulling the ground wire/phono cables through the hole in the armboard, but it's not too bad and it all turned out well.  In case you're wondering, it's apparently recommended to place the flat side of the shim against the arm board and the recessed side against the base of the arm.  Someone on this forum and my audio dealer confirmed it, although I couldn't find anything official from Rega that stated that.

Very helpful info, thank you. I need to reconsider the Acoustic Signature solution. It looks like you have the ability to make adjustments in .5mm increments. I don't think it matters for the Blue, but it might be nice to have options for the future.

Had a P10 with a Hana SL. I used a Funk Firm achromat 3mm which provided the right height. So avoided to use a shim. Otherwise there is no choice to compensate since there is no VTA adjustment on the Rega. In any case I have been using the Achromat on three different turntables and the sound is much better than the original mat provided in all cases. My latest set up is the Hana Umami Blue on a Linn Akurate. Fantastic!

That's a really good solution, but I think I would need the opposite for the blue -- reduce my mat size by 1.8mm.