Ortofon MC X30 broken cantilever - what are my options
I purchased this cart about 3 months ago. After playing a record yesterday, I noticed the Cantilever was slightly askew towards the center of the record. I decided to brush it lightly with a dry stylus brush to see if something was loose. The cantilever fell off. I do not recall any event that could have damaged it but you never know.
I have sent a message to Ortofon - but what are my options? This is my first time with a broken MC Cart.
@maam522a I suggest that you also ask Ortofon to tell you the reason for the cantilever failure. If it was caused by a manufacturing issue, they should take particular note of the problem so that the appropriate countermeasures can be put into place. If it was caused by something that you did, you want to know what to avoid or be careful of so that there won't be a recurrence in the future. Best of luck with the replacement cartridge! |
Totally aligned with your comments. Since this is a new product line for Ortofon, then they definitely need to determine if there is a defect in the assembly process. The cantilever was still embedded in the cartridge suspension material and not bent or broken on the outside exposed section. It was cocked to the side and when I touched it with the brush it pulled out and came off. It could very well be something that i did, and as you stated - I certainly want to know what that may have been. |
Best of luck with Ortofon. I just want to let others know, Audio Technica has a program, I sent mine in suspecting it was near 1,000 hrs, they confirmed it was still ok, not causing damage, but not for much longer, and I was able to purchase a new replacement AT33PTG/II for just under 50% of the cost of new. Soundsmith also has a program that is relatively inexpensive to re-tip their cartridges. Here in New Jersey, USA I and most of my friends have used Steve and Ray Leung at VAS to repair/build cartridges.
|
Depending on how Ortofon responds, I may consider sending the cartridge to Soundsmith. If Ortofon only offers a 25% discount off of new, then the cost would be over $500. Soundsmith can replace the aluminum cantilever with Sapphire, Ruby, or even Boron with the same profile Nude Diamond for less than that. Essentially upgrading it to the MC X40 level. I will look at VAS as well. Thanks. |
I didn't realize Soundsmith worked on other brands cartridges, and the prices seem pretty good. https://www.sound-smith.com/options-cantilever-and-stylus-shapes VAS may be a faster turn around, I have heard 'slow' about Soundsmith, but have no direct experience. VAS has always gotten me and my friends done rapidly. I feel lucky to live only 35 minutes from their shop. |
