Iamatthewj.i just put it on normal phase.
@jayctoy , here's my question about that:
The manual explains that the USA system is pin 2 is cold, pin 3 is hot; versus the European system which is pin 2 hot, pin 3 cold; on both systems pin 1 is ground.
The manual states that "This unit employs the European system."
Then it goes on to state that "If a product that employs the USA system is connected with this unit [the SA10] via a balanced cable [which I am using], the signal may be phase-inverted. To correct the inversion, set the "Phase" to "Inverted" at the menu setting."
My SA10 is connected to my preamp, which is a Cary SLP 05, via balanced cable, and Cary is not saying in their manual whether they are employing the European system or the USA system so I am ASSUMING that they went with the USA system.
So as I understand the SA10 manual, I should be setting the Phase on my SA10 to ’Inverted’? Since my preamp is using the USA system?

