How to fix my detailed, accurate but BRIGHT system

I'm in total agreement with BlindJim. Often enough, it's not the gear but how it's setup.

Did you say Changing Wire or Changing Wife?

You know one letter could make all of the difference in sound quality! (LOL)

Only Kidding!

Thanks for the explanation Al, but I need to read up more about this subject, so I think I'm going to get Robert Harley's book and some others that I've heard about here, because I would certainly like to understand electrical impedance mismatches better.

Rich

I have several pairs of Aerials including the 7Bs. I've run a lot of different amps on the them. I found they sounded all sorts of different depending on the amp. I'm sensitive to highs in recorded music so it was an especially important point to me that they sound right. I also had a number of other speakers and can't say that the highs really change all that much from speaker to speaker. Also, the Aerials are so well built that's it's very easy to have them up too loud and that ends up being painful. I settled on McInitosh and also Bel Canto. You can't beat Mcintosh for smooth pleasing highs IME. I've got the 7Bs in the bedroom now running off Bel Canto's S500. The BC has stronger highs and dynamics than the McIntosh but I would say the highs sound good. Surely the room has something to do with it but if I were you I'd be in the market for a different amp. The Aerials absolutely sound different depending on the amp. I would even go so far as to say that in a blind test with the 8 or 10 amps I've tried with them I could dicern which amp was being used with them.

it has been suggested that a slight alteration of speaker placement might help. i suggest a slight toe-out of your speakers. if you don't like the sound, you can easily reposition the speakers. make sure you use tape to mark the position of your speakers, before you move them.