Upgrade decision, power conditioner or music server


I am an old audiophile starting my journey in the 70s. I have been a member since 2010 but this is my first post and ask. However, I have enjoyed your back and fourth for years in the weekly review email and I learned from the experience.  I recently changed some of my account parameters and for some reason my account says member from '23.  I am currently building my end-game system within my economic means for retirement.,  Most of the system was purchased pre-owned.  

The room and shelving look worst than they are.  A photo is in the virtual systems tab. The living room is 20'x12'X8' and vents to the left to a 12'X14'X8' L-shaped dining room and to the right to hall and stair case to the second floor. I listen on the width about 7' from the speakers.  Frequency response if fairly flat and standing wave reinforcements or cancellations are not evident due to venting.  The WAF set-up is mitigated by diligent vibration control tools. Besides my room and WAF shelving in a wall unit, which cannot change, I see the weakest links in my system as my power conditioners and music server.  The budget is $3K plus anything for trade in which will only be about $400 or less for conditioning or $900 for the server.  I can only do one or the other.  

I am looking for assistance in determining the greatest benefit/investment ratio.  For conditioning upgrades I am looking at a preowned Shunyata Denali or Audience AR T3.  For a server upgrade, I am looking at the Aurender N10.  My system is listed below and described on the virtual systems tab. If you see another weak link that you feel better to upgrade than conditioning or the server, let me know. I look forward to any assistance from the community in making this  decision.  

Vivid Audio Giya G3 Series 1 Speakers, Krell KSA 300s Amplifier, Krell KRC HR Preamplifier, with KPE Phono Board, VPI TNT 3.0 Turntable upgraded with current platter/bearing, JM Memorial 12.5 Tone Arm, Benz Micro Ruby Cartridge with SoundSmity Boron Cantilever and Tip,  Audiolab 8000T Tuner, Wired 4 Sound 10th Anniversary DAC, Aurender N100H Server, Shunyata Hydra 6 Conditioner (Pre and Power Amp), Audience AR2 Conditioner (Digital), WyWires Platinum Power Cords, Interconnects, and USB Cable, Audio Art Statement Bi-Wire Speaker Cable. 

Look forward to your comments.  Yes, you can have your fun grilling me on the WAF setup.  I know it is bad.  Perhaps when my wife retires and if we decide to move out of NY with its insane taxes, real estate cost, and general COL, I will get to have a room designed for my system.  Look forward to your assistance.  

jsalerno277

Thank you.  No, I cannot do any of your recommendations.  Moving speakers will block flow patterns,  the wall unit is a WAF requirement, the wall unit glass reflections is possible where I can buy a panel and put it in place for serious listing, I never thought of that.  There is no artwork.  Between the speakers is the massive wall unit.  Doors were open for photographs.  For serious listening, doors are closed.  The door for the preamp shelves is left open just a crack.  The Krell IR remote woks well with minimum opening.  

Thanks for the suggestion on the acoustic panel.  

The Shunyata Denali would be much  better than the Hydra 6 you have. Last yearI  upgraded to a Denali (v1) from a Hydra 8 so similar change and it helped everything.

For some additional color, before the Denali I plugged the amp into the wall directly because the H8 wasn't helping at all so I was happily surprised when I tried putting the power amp through the Denali as well and found it to be a nice improvement. I have a 12 Amp power amp and the draw didn't bother the Denali at all.

Enjoy the very nice system!

With the Denali everything became more natural sounding and dynamic in my system with a quieter background. No negatives noted.

CALL MIKE at Tweek Geeks and order a 30-day trial on the QSA Jitter Conditioner red or red/black plug.  Plug that into the end of your conditioner to the wall outlet.  What have you got to lose?  It makes a big difference.  I purchased the silver one with really good results on my system.  You may not need tp upgrade any of your components!!!

ddrave44 and Willgolf

Thank you.  I am a firm believer in clean power and I am siding on moving to the Denali vs improving the server to the Aurender N10.  However, reviews also indicate a big difference in the N10 vs the N100H.  

Thank you.