Question About Capacitor Upgrade in Tube Amp


Hi,

I am preparing to do a coupling capacitor upgrade on a recently purchased tube integrated amp. The two 0.22uF on the preamp tubes are fairly straight forward. But I noticed another similar model 0.33uF cap on the large filter capacitor for the B+ supply that is installed across the hot lead to ground.

Does this cap on the B+ just block high frequency noise from the power supply or does it have any effect on the amp tone? Is there any reason to "upgrade" this cap?

I know it may be hard to tell exactly what is going on without a schematic.

Also any recommendations on a good cap to use in the upgrade of the coupling caps? I was looking at Mundorf SilverGoldOil for the quality at not too crazy a price. The amp already sounds good but lacks a little clarity that I think a coupling cap swap will help with. It is SET 300B amp.

Thank you!

 

calieng

The elephant in the room that no one notices is Power Supply Impedance and Phase. It is perhaps the most important and neglected aspect of HiFi design.

Capacitors have two frequency dependent properties, ESR and ESL, often ignored by engineers and almost certainly by Joe Audiophool.

The amplifier circuit, if perfect, does nothing more than regulate the power supply. If the power supply has poor phase and impedance, it passed on to the next component. Sequential components alter the preceding and this is why a really great component may get so-so response in one reviewer's system and sterling accolades in another.

Sequential components & cables all add their sonic signature.

Hence, when Walter Wannabe audiophool swaps out ReallyGoodMatch for  BigFatSilver caps, he is altering his entire system and any perceived change, improvement or not is only valid for his system.

Add in the $$$$ and time incentive, and of course it's better.

I received the Mundorf Supremes last night and got them installed this morning.

Initial impression: Upper frequencies which were rolled off are now fully there. Cymbal crashes and other higher frequency elements that were in the background or missing are now fully there.

Bass that was previously full is now taught, well defined with some punch. Best bass in a 300B SET I have heard so far.

For a little over $100 and a few minutes of time the coupling cap upgrade in this Willsenton R300 is an absolute no brainer. It is a must do upgrade. The amp is sonically deficient otherwise. So for under $1400 for amp, shipping, and upgrade I have an amp that sounds amazingly rich, holographic, and musical.

Thanks again for all the advice. 

@calieng 

Congratulations with your positive outcome. It seems that the stock coupling capacitors were a sonic bottleneck. I’d say that was 100 USD well spent.

Charles

Vcap CuTf are great for 300B SET - clean, clear, transparent, fast, soundstage not harsh at all.

Duelund Custom are excellent too - great tone harmonics, soundstage, a little bit slow and full bass.

Bu I think these two options are too expansive for such not expansive amplifier.

Does anyone compared directly:

1. Vcap CuTf vs Mundorf Supreme Silver Gold Oil?

2. Duelund Custom Cu vs Cu-Sn versions?