Casters to replace spikes


So I'm sure this will get a lot of challenge and flak, so please helpful comments only!

Long story short my focus has changed from home theater to two channel back to home theater.  Recently got a projector and in the midst of getting a screen (have a white sheet hanging as temporary) . On a whim I moved my Revel studio 2s and Voice 2 behind the sheet which improved the movie experience 1000%. However I had to push the speakers back against a wall, which is not ideal for two channel listening. I'm planning to purchase an electric screen so on occasion I'd like to be able to pull the speakers out from the wall with little effort when the screen is rolled up. Right now they are on the factory spikes sitting on Herbie's discs, so they can slide on the carpet with some effort. However, every time I've seen Wilson speakers in show rooms, they always seem to be on casters which made me wonder if that's a normal type of arrangement or at least a good enough arrangement.  my system is decent but my room needs lots of treatment so I'm taking an 80/20 approach here.  

Has anyone done this/ can recommend any type of solution for being able to move the front speakers with ease?  Thanks!
esthlos13
Check out Mockett  CA39PB-90. 65 lb. capacity x 4 = 260 lbs., low profile of only 2 5/32" height. The lower the profile, the more stable it will be. This is a tall package with a narrow footprint, not ideal for casters but if you keep them small in height and install them as close to the outside corners as possible, it might be OK with careful handling. I usually do not consider casters on anything under 18" wide, especially if the object is tall and heavy.
http://https//www.mockett.com/ca39pb-90.html
esthlos13:

I have a pair of Wilson Audio Alexia and I had them on the casters for quite a while, ever since the Dealer dropped them off and set them up, and the left them on the casters. Later on I conjured up the courage to put them on the Wilson's spikes that the speakers came with. In so doing I noticed that the bass was missing and at that point I went and got two JL Fathom subwoofers to enhance the bass. They did such a fine job that I got complaints, These subs are quite powerful. What I did next is to eliminate the subs and got Isoacoustics Gia Titan speaker isolators for the Wilson Alexia. I had some issues with the screws and lugs at first because I got the wrong ones. I waited a few weeks before I got everything in order. And I must tell you that it was worth the wait. I waited almost 4 weeks before I made any public comments about the results I was getting from my listening sessions after I installed the Gias. It was unbelievable, I didn't expect such a difference. The bass was punching, soundstage was wide and focused; everything sounded just like I wanted it to sound from the beginning. I waited 4 weeks, just listening to the system every day to see if anything would change. In the past I got expensive interconnects and the system sounded great but after a few days it wore off and I could not recover the initial experience. So after installing the Gia Titans, I waited just to make sure that what I was hearing is really what I heard from the the start.

So my advise it to take your speakers off the spikes and get some speaker isolation feet instead. At least try it, because everyone's setup, hearing, etc. is different.
@almandog I sounds like moving from casters to spikes was a downgrade in your experience. Then moving to isolation feet had the effect of returning to the caster-sound plus some? Or did the Gaia's just get you back to were you started?

It's my experience that using isolation feet is a giant improvement vs resting the speaker directly on the ground. I use Herbies Gliders now, but Gaia's were my other option. I haven't tried the Gaia's yet. 
Hello, I have Omicron accessories under all my stereo system. Better performance than spikes, no way, at all! Carefully you can move/adjust the position of your stuff without scratching the floor.