testing a crossover


hi guys and girls i have a
problem with my 3 way  wilmslow-audio mirrage speakers , I am hoping you can help me with the problem,.
Lately my power amp went pop and i sent it away for repair,when i
received it back {repaired} it went pop again,on sending it back to
the repair technician ,he has come back to me ,and asked me to take
some ohms readings on the speakers, on testing the speakers , i run
these speakers using 2 power amps{Arcam Alpha 10s,using one for low
pass{bass} and the other for MID/HIGH,this is the amp which keeps
blowing,on the high /mid,on testing the terminal the bass{low pass}
read {left speaker]7.9 ohms ,right speaker bass 6.8ohms, But on the
left and right speakers hi/mid ,both read 0.0 ohms,{which we all know
is wrong}
BUT the strange thing is,when the blown amp was away,i only used one
power amp to run both speakers in bi wire config,and they worked
ok,all being a bit lack of bass and tightness,but still sound great.
So i stripped both speakers and checked the drivers,all 6 drivers
where good no shorts reading approx correct ohms for age,{Speakers
disconnected from x over}.can any one help with this,i would be so much in debt.
kind regards Mark
likklegerry
@likklegerry   
sorry,  I just saw this.  PM me, I'll help you figure this out. 
Tim
@likklegerry    Sorry,  I haven't heard from you, So you may not want my help at all, but I just started a new job.  I'll be working a ton of hours for awhile.  Won't be able to help.  Tim
Hi Tim,so sorry i havent gotten back  to you,ive been trying to to fix this problem online with another guy,but for me,my end,my laptop is very old and slow,and have been waiting to receive a new one from the UK,and it all takes time,living in Bulgaria,thank you so much or your offer,it is very much appreciated, I wish you all the luck in the world,with your new job and thank you again for your amazing offer.   kind regards mk.
PM me,  I'll answer when I can, but there are things to check that have not been mentioned. This can be figured out.  It may well be a driver problem, if not, I can draw new crossover schematics for you with a few improvements if you can build them.