2. analog
  3. 147491-123735

Did Fleetwood Mac's "The Chain" blow up my woofer?

System: Ortofon 2M Red > Musical Surrounding Phonomena II > PS Audio Stellar preamp > M700 monoblocks > Buchardt S400 

Phonomena is set to 46db of gain, 200pF capacitive, 50k Ohms resistive

The other day I was playing "The Chain" off of Rumors, and one of the woofers stopped entirely during the bass guitar interlude. It just went completely silent, no pops, crackles or distortion. The tweeter is fine, and I reversed the L and R channels to confirm this problem is in the right woofer. The volume level was a "strong" listening level (30 out of 100 on the Stellar), but not loud. We were still able to converse just fine without raising our voices much at all. I have certainly listened to these speakers much louder with other sources.

I understand the power amps are overkill, but I figured my ears would bleed far before I was in danger of blowing anything up. Was this distortion? Subsonics? Woofer pumping due to poor TT isolation? Or a simple defect in the driver?


jayy42
rocknss
130 posts
 
Here is a pic of the crossover, if you can get to it and have a meter I would ohm out those resistors.

forgot link
https://www.buchardtaudio.com/shop/s400-black
erik_squires
15,692 posts
 
Fortunately, resistors in a crossover that go bad tend to turn black, along with nearby parts suffering from too much heat, so a visual inspection is often helpful.

But swap the woofers, that will tell you if it truly is the woofer or a crossover issue.

big_greg
6,558 posts
 
I have blown up woofers before due to pumping when using a turntable.  This can happen at lower volumes than when using other sources. 

If you (gently) push against the woofer and feel resistance / scraping it's probably the woofer.

Once you get the speaker fixed, see if you can fix the rumble problem with a filter, better isolation (my first choice), etc. or you're likely to do it again.
jayy42 OP
4 posts
 
I suspect woofer pumping is the culprit here, but I am seeking advice. Right now the components are stacked on the floor while I wait for my new media console. 

I didn't see any burn marks on the woofer or the stuffing around the crossover. I have a new woofer unit on the way. 

I am thinking about a maple shelf with sorbothane feet on which to place the TT along with a KAB RF-1 filter. Hoping that will eliminate the potential for rumble/pumping in the future. I already have sorbothane pucks between the speakers and the stands. 
rocknss
130 posts
 
Fortunately, resistors in a crossover that go bad tend to turn black, along with nearby parts suffering from too much heat, so a visual inspection is often helpful.
These are large ceramic power resistors. I don't think that they usually turn black, at least I know that I have seen them when they didn't.

Doesn't look like these speakers have any fuses, so hopefully they designed them with at least one of these fuses as the weak link.
More to discover