George excerpted a quote from Nelson Pass's website. It makes it look like Nelson had a certain position on the subject, but if you read what follows, you might see that such is not the case. Here is that further text (I've included the end of the text that George quoted earlier):
And yet there are guys out there who don’t care for the result. “It sucks the life out of the music”, is a commonly heard refrain (really - I’m being serious here!). Maybe they are reacting psychologically to the need to turn the volume control up compared to an active preamp."
I suppose if I had to floor the accelerator to drive 55 mph, maybe I’d think the life was being sucked out of my driving. Then again, maybe I like 55. Nice and safe, good gas mileage…
Is impedance matching an issue? Passive volume controls do have to make a trade-off between input impedance and output impedance. If the input impedance is high, making the input to the volume control easy for the source to drive, then the output impedance is also high, possibly creating difficulty with the input impedance of the power amplifier. And vice versa: If your amplifier prefers low source impedance, then your signal source might have to look at low impedance in the volume control.
This suggests the possibility of using a high quality buffer in conjunction with a volume control. A buffer is still an active circuit using tubes or transistors, but it has no voltage gain – it only interposes itself to make a low impedance into a high impedance, or vice versa.
If you put a buffer in front of a volume control, the control’s low impedance looks like high impedance. If you put a buffer after a volume control, it makes the output impedance much lower. You can put buffers before and after a volume control if you want.
The thing here is to try to make a buffer that is very neutral. Given the simple task, it’s pretty easy to construct simple buffers with very low distortion and noise and very wide bandwidth, all without negative feedback.
There are lots of different possibilities for buffers, but we are going to pick my favorite: