Stillpoints Ultra6 reference vibration controlers?


Category: Amplifiers

I started to work in audio in july 1998. I remember that the first day I started I had a blocknote with me. I started in room 1 of the loudspeakers. Here it all started to write down properties of each individual tool. For a long time I was addicted to audio. I was busy with audio for 80 hours a week. It was never enough for me.

Almost 17 years later I have done thousands of tests in audio. From the mid level till highend. I became aware that I could judge and understand audio a lot more easy than all my collegues. But I never understood why. Untill in 2012 I became aware that I have a photographic memory in sound. I trained this part of my brain for a long time. Every single audition I can recall. So a second audition I see in front of me and the first one is on the left side. Within a few tenths of a second I know already the difference between them.

When you are aware of all the properties of each individual 'tool' you will see and understand the patterns between them. And you will understand the connections between them. This means you understand how the stage and overall sound has been created. I can see 3-4 steps further than other people in audio can.

I judge every single tool on what I call Total Sound. Total Sound is like a blue print of the original sound. When I audition sets from 'new' clients, at shows or at another audio shop in almost all situations it is what I call 'incomplete'.
In most 'new' sets I need to bring in parts of Total Sound to make it complete. At the end it is so much more addictive to listen to any set I 'repaired'.

Parts of Total Sound:

- Soundrealism: you want and need an instrument to sound like
in real. I use Pass labs amps to the max for this. It is the
focus on sound of each different instrument and voice. For
example: you want to hear the difference between 2 acoustic
guitars of a recording. I always want to hear the full
pallet in the mid freq. The timbre is an essential part
of listening to music

- 3 dimensional soundstage: this is the most exiting part of
audio in general. This sets your beloved music in full 3D
in front of you. During listening you can focus on each
individual part of a recording.

- Intimate sound: instruments and voices are very small in
dimension and very direct in sound. You want a realistic
proportion of instruments and voices. Intimate sound has
a very big influence on our emotion.

- Blacks: The space between the instruments and voices with
their acoustic information during the recording. This is
level of physical appearance. You want to touch every single
instrument and voice of the recording. Germans use the word
'darstellung'.

- timing and speed: it is a very important part for authority
and control of the overall sound. Better timing will give
you less acoustic limitaions. But also a more natural sound.
Biside this you also can reveal more layers of the low freq.

- Resolution: you want to hear all details of the recording.
And it needs to be physical apparent.

- Air: This part gives the instruments and voices the freedom
during listening. Separation makes your music so much more
appealing.

- A big freq. response: When your system goes deeper in freq.
response you will hear more information of a recoding. This
also has a big influence on our emotion. People can hear
till maximum 20 khz. But...the freq. response above it
influences our brains.

- articulation of voices: how clear you can hear word
endings, breathing of singers and moving lips.

- heights: When I received 2 sets of the Audioquest Wel
Signature xlr's it became more clear than ever. It makes
listening to music different and even more appealing.

I wanted to tell this information first before I start with the review of the Ultra 6. Because it makes it much more easy to understand how I work. By using tools for their properties you always will reach a superior endresult in sound. For a perfectionist like me you always go to the max. There is no room for error.

When you have done thousands of tests like me, you are aware of how important and unique the working of Stillpoints are in your set. I am a stillpoint dealer and use many of them in my set. They are an 'essential' part for the absolute sound. Why? Because they can add 'new' qualities I could not create with other tools.

At this moment we speak I do a lot of research with new tools and systems. I call it creating a new 'statement' in sound. Because I want to reach a higher endresult than ever before regardless price in audio. It is a higher level of accuracy and realism than before.

Without Stillpoints I would not be there were I am at this moment. When you compare the Ultra 6 against the other Stillpoints you know how much better they are.

I put them under my Pass labs X350.5. They operate in a different league. They even bring your set into a new zone. Like it puts your set into pause and it sets your music free. Your stage becomes wider and deeper and you get more air around all instruments and voices.

The mid freq. becomes more involving than before. Also the authority and control of the mid freq. is more precise.

When you compare amps or sources which have a huge difference in price ( 2000 dollar against 10.000 dollar+) you will never have this difference in timing the Ultra 6 gives to you. It is mindblowing in what it does with the speed and timing. It becomes so much more accurate and refined.

I noticed that the sound of a piano and cello becomes so much more natural sounding.

In the high freq. you will reveal more details. And again the control and authority in the high freq. gets to a much higher level.

The low freq. go deeper than before with a much higher level of authority again. You hear more layers but beside this the natural sound of a bass drum has never sounded this 'real'.

I am the first person who bought then in the Netherlands. And I am thrilled to own them. They are a crucial part of my set. They will have an important part for me to be able to create a new 'statement'in sound.

When you ask me the question; are they expensive? You know they are even rather cheap for the quality and level they bring. I'll love them till death!

Sound&Vision Consulting 16-2-2015
128x128bo1972
I also use Stillpoints under my source.

http://forum.audiogon.com/cgi-bin/fr.pl?ddgtl&1402683335&openmine&zzBo1972&4&5#Bo1972

http://forum.audiogon.com/cgi-bin/fr.pl?cspkr&1412459690&openmine&zzBo1972&4&5#Bo1972

Under speakers and a subwoofer they also have great results.
The preamble with your definitions is pretty great. I'm bookmarking this thread for reference.

Hello how are you one palcer, I live in Argentina and I am known orionpc, he put the debate that amp is better for Wilson Sasha, I tell you as I see you got doubts the line 8 of Pass Labs, in my opinion are a great step forward against the line .5 at all, much more fluid sound, enhanced bass, treble sweeter, less noise, resulting in much better stereo image with better recreation of instrumentalities !! I have extensive experience in pass Labs , XA-30.8, and sold three units, and all customers !! fascinated, I also sold about 8 months ago an X-350.8, with speakers B & W 802Diamond, and the truth is that the result was magnificent !!! much higher old X-350 speakers use !! Tell me that, and I give my opinion !! also I really liked your review of Purist powercord Limited Edition, this marac sell it more than 12 years ago in Argentina and the LE, is the cable I use in my Esoteric K-01X, in my pre Pass Labs XP-30, also concidero that is sensational !! I recently bought the powers Pass Labs XA-160.8, and the truth is that are incredible !!! Maybe I pass my system! These replaced a Krell CX-700, which I still !! also excellent !!!
I also agree with you that are Stillpoint not believe !! They are expensive but when you put in the balance, contributing to improved sound worth it !! I use Ultra Five 8 units, for my Wilson Sasha 2 and have three units Ultra Six bases, below the Esoteric K-01, the clock Esoteric G-02, you place 3 units of Nordost Sort Kone BC, and power Pass XA-160.8, I put 3 units of Nordost TC, the pre XP-30, for a subject high you place loas base HRS NINBUS SISTEM, the XA-160.8, powers powercord place les 2 Furutech NANOFLUX, they are also at the height of the LE Purist or even are even better !! in Shunyata Triton I have a powercord ANACONDA ZT, and the Esoteric G-02, have a Shunyata Digital Sigma, cable IC, I Purist Canorus Praesto XLR pre and power, and for K-01, I have Transparent REF XL MM2 optimized for K-01 / XP-30, but alternate with Furutech Lineflux and Kimber Select 1136, and finally to speaker cable use a TRANSPARENT REFERENCE XL MM2 custom Wilson / Pass, the last thing I need is the BNC cable for the clock there I have, Purist Canorus, Transparent REF XL, and Furutech Digiflux with Rodhium Carbon connectors, also the Limited Edition of Purist replace them with the original x Furutech FI-50/51, as tokens of current to the wall Oyaide use F-1 and a Furutech GTX-D (R) Good any doubt your orders !!!

Best Regards

Adrian Molina