Help I have a radio in my tweeter


Was listening at low levels last night and heard some offputting sound coming from one speaker - kind of a light scratchy sound - put my ear to the tweeter and found a lot of static and a barely perceptible sound of voices. As I listened further it became clear that my tweeter is picking up a radio station from somewhere. I don't own a radio so it's not in my house. Something is acting like an antenna.

I have a tube preamp and when I turn it off or take it out of the system and use the pre section of my integrated SS amp in its place, the issue disappears.

So with preamp as the apparent source of the issue, one at a time I changed out all tubes for others, changed the power cord, plugged preamp it into a different circuit, changed interconnects running from pre to power - still have the problem.

Not sure of next steps - any thoughts?
Ag insider logo xs@2xitball
Thanks for all your responses.

It doesn't seem like a HAM issue - I can make out enough of the detail such that I'm fairly sure it's a radio station. But it does come and go - have not heard it since this morning.

Hmmm...
I've also had this problem.... and the guy who sold me my speakers/cables had it too. Some ers cloth wrapped around any exposed connectors helped a bit. This problem is a real pain - you have my sympathy.
In the field of pro audio where I make my living, this comes up regularly. The trick is to give the RF a place to GO, besides the next stage. There are many ways active electronics can demodulate, downconvert, and heterodyne with RF emissions that get caught up in open circuitry. Also, some exotic cable designs give up shielding for the idea of supposed lower impact on the musical signal. Here are a couple of tricks I have in my bag:

Move your gear a few feet! RF energy pools like invisible currents of water, with nodes of dead spots and peaking stronger areas. There is a chance that multipath can work for your here, and you can find an arrangement that will kill the radio show, in a cancellation node (the fence board part of the "picket fence"). Moving cables around can help.

Try different cables. Start with a cable with a clear design goal of minimizing external influences, that has a solid shield, braided, with a drain maybe, or even foil and a drain. Stay away from twisted pairs and no shield. Unplug and plug in all of your connections; some patina/corrosion can act as a crystal set to demodulate AM broadcasts.

Buy clamp-on RF chokes. They come in several shapes and sizes, and can reduce the effectiveness of your cables as antennas. Try them on your power cord or input/output cables.

Buy some ceramic disc capacitors. If you know your way around high voltage circuits, bypass power supplies, high impedance stages, and inputs and outputs with values ranging from a few hundred pF to 0.1uF. The idea is to provide an alternate path for RF energy away from the circuit that is demodulating it, without impacting baseband audio below 20kHz. These parts should ALREADY be in your gear. There is a chance that a lead or solder joint on a cap has failed, as indicated by the fact that only one channel is affected. If you're not so sure what is running at 90V to 350V in your tube gear, don't mess with the insides (for your safety), just try the external connections.

Lastly, double check for tight screws on the chassis. Again, sometimes a little corrosion takes on the form of an oxide that acts a bit like a diode. Unscrew and retighten all fasteners that go to PC boards, ring terminals, and metal parts.

Good luck!

:)