Mono amps...


are they all basiclly bridged stereo amps or are some designed with a clean sheet of paper as mono amps? I am asking because I have had monoblocks for more than a decade and like the idea of isolating each channel and having the amps as close to the speakers as possible (in fact I miss stereo consoles...just kidding). Being in the market for Bryston 7B-STs, I asked whether they are, in fact, bridged 4B-STs and was assured they are not. Looking at a review of them, however, I read that they are, indeed, bridged 4Bs. Why I should be concerned about this is not clear even in my own mind. I know there are pros and cons to bridging. The slew rate is dsoubled, if I remember correctly. What it all means is a little more blurred. Any thoughts?
pbb
I used to own the 7B STs. There are two modes that these amps can be run in, series (voltage), or parallel(current). I believe the series mode is for impedances > 4 ohms, and may in fact be a bridged 4B when run this way. Parallel mode is for lower impedances, < 4 ohms, or where high current is required. The output ratings for parallel mode are less, but still very powerful. The two modes sound slightly different as well. Series mode has an airier presentation, with a slightly more diffuse soundstage then parallel. Parallel mode is drier, but has a nicely focused soundstage, and controls the speakers more firmly. The 14B looks like it uses one large transformer per channel vs. the two per 7B monoblock.
Regarding "Asterix" generalized comment about reduced sound quality from bridging .......
Cello's Performance amps when bridged produced thousands of watts and sounded better than when not bridged.

Richard
I have experienced what " Asterix" comment in a nutshell. My two Classe CA-400 bridged exactly did just that, confirmed later in so many words by Classe.(more power -experienced by improved control, effortlessness, deeper sound stage. Overall sound quality degreded due to higher noise floor, thinner,midrange suck-out, ambient sound-result: worst compared to stereo mode)