With my Monoblocks and one REL subwoofer, I have one hot wire (red) to the + speaker post of one amp. The other hot wire(Yellow) to the + speaker post of the other amp. And the ground (black) to the - speaker post of one of the amps (either will do) Sounds great!
Wiring a subwoofer to monoblocks
Just picked up a REL Quake
REL's manual speaks about differential amps – does this mean
Mono blocks?
No friggin idea how to wire it up.
My i/c’s are fibre optics which break the ground between boxes so wiring the earth to the pre is no use.
To make matters worse, the Audiopax reverse polarity /phase.
Have mailed REL but no reply.
When the manual speaks about wiring to the chassis ground,
How do I check this?
Next problem will be a plan to use two subs and I'm not any clearer from their manual how this will be achieved.
I have spare pre outs on the Supratek but would prefer to run the the sub/s using the hi level inputs.
REL's manual speaks about differential amps – does this mean
Mono blocks?
No friggin idea how to wire it up.
My i/c’s are fibre optics which break the ground between boxes so wiring the earth to the pre is no use.
To make matters worse, the Audiopax reverse polarity /phase.
Have mailed REL but no reply.
When the manual speaks about wiring to the chassis ground,
How do I check this?
Next problem will be a plan to use two subs and I'm not any clearer from their manual how this will be achieved.
I have spare pre outs on the Supratek but would prefer to run the the sub/s using the hi level inputs.